ADEMCO Alpha Vista Console Manual de instrucciones descargar pdf (Pagina 9)

one armed period.

The communicator will transmit a restoral message

when the zone is restored (less than 1 second).

Type 10. INTERIOR DELAY ZONE: This type of zone will always have Entry

Delay #1 and Exit Delay #1. This zone is not enabled after arming

until termination of the programmed Exit Delay #1.

If this zone is

faulted, three beeps will be emitted by the Console.

If the security

code + OFF is not entered before termination of the programmed Entry

Delay #1, an alarm will be initiated.

A system-wide programmed nwnber

of alarm reports for this zone will be allowed to be transmitted

(swinger suppression) by the ccinmunicator in one armed period. The

communicator will transmit a restoral message when the zone is

restored for a time greater than its physical response time (less than

1 second).

During the disarmed state, a faulted zone will result in a “DISARMED—

Press * to show faults” display (5137) or aNOT READY display (4137).

Subsequent depression of the * key will

and/or numbers of the faulted zones to be

communicator reports will be initiated.

cause all the descriptors

sequentially displayed. No

TABLE A. ZONE ASSIGNMENTS

A zone type must be assigned to each physical zone in use. For convenience, the

following chart has been prwided for checking off selections made.

PHYSICAL ZONES

ZONE TYPE

1 2 3 4 5 6 7 8

1. ENTRY/EXIT, Delay #1

(Burglary)

2. ENTRY/EXIT, Delay #2

(Burglary)

3. PERIMETER (Burglary)

4. INTERIOR, FOLLOWER

(Burglary)

5. TROUBLE BY DAY/ALARM

BY NIGHT (Burgtity)

6. 24-HOUR SILENT

[

7. 24-HOUR AUDIBLE

8. 24-HOUR AUXILIARY

9. FIRE ZONE*

10. INTERIOR, DELAY

(Burglary)

* Physical Zone 9 cannot be used for Fire.

** Available when 4152LM and 4208 Zone Expander used.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de instrucciones Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console