
NOT USED
[0] MUST BE ZERO
TRST REPORT
INTERVAL
PWER UP IN
PREVIOUS STATE
QUICK ARM
TOUCH-TONE OR
ROTARY DIAL
PAM ACCESS
CODE
*26
*27
*28
*29
*3O
*31
[1
COMMENT S: Determines
time period between test
reports.
Enter O (no report),
or 1 (12 hours), 2 (24 hours)
or 3 (168 hours).
Must be used in conjunction with Data Fields *83
and *68 (location 5).
If low battery testing that
automatically removes AC power is desired, enter a
non–zero number even if test reporting is not
desired. At the interval selected, AC pcwer will
be disconnected and the battery will be tested
under auxiliary current load.
[1
COMMENTS:
If selected (YES), on power-up the
system will assume system status prior to power
down. If not selected (NO), the system will parer
up in disarmed state.
Enter O (NO) or 1 (YES).
When the system powers up armed, an alarm
will occur 3 minutes after arming if a zone is
faulted. When so armed,
reports closing as User #7
if open/close reporting for User #7 was enabled in
Address *52.
[1
COMMENTS: Enables arming of the burglary system in
any mode without use of a Security Code (just #
key depression followed by the command AWAY, STAY,
INSTANT or MAXIMUM). When armed AWAY or MAXIMUM,
reports closing as User #7 if open/close reporting
for User #7
was enabled in Address *52.
Enter O (disabled) or 1 (enabled).
[1
COMMENTS: Permits selection of the type of dialing
to be used.
Enter 1 for Touch-Tone, O for Rotary.
[1[1[1[1[1[1[1[1
COMMENTS :
If not required, enter nothing and
proceed to next address; otherwise, enter prefix
needed to obtain an outside Telco line.
This
field may be used alternatively to enter a prefix
that can suppress the Telco’s call waiting feature
fran interfering with outgoing transmissions.
This prefix is only useful if the Telco option to
be able to suppress call waiting has been obtained
by your customer. The prefix to be used is 1170
if pulse dialing is being used or *7O if TouchTone
dialing is being used.
Enter up to
4 digits. Each digit requires a 2–
35
Comentarios a estos manuales