ADEMCO Alpha Vista Console Manual de instrucciones descargar pdf (Pagina 23)

FUNCTION PROCEDURE

ENTER PROGRAMMING MODE: 1.

POWER UP, then depress * and # simultaneously

within 30 seconds of powering up.

2. Initially, Key:

4+l+4+Oplus~DE key+ 0+

After Installer Code is programmed, key: Inst&l.ler

Code + CODE key + O + O.

Notes: User #1 (installer) must be enabled (in

Address 52) if ~pe 3 method of entry is to

be used.

Type 3 method of re-entry to the programming

mode is inhibited if the programming mode is

exited via use of =8.

Type 1 method of entry can always be used,

unless console programming has been locked

out by the remote downloader.

EXIT PROGWING MODE:

*9 (always allows re-entry to programming mode via

Type 3 entry method above), unless console

programming has been locked out by the remote

downloader) .

*8 (inhibits re-entry to programming mode via Type 3

entry method).

Note: When the programming mode is exited, a I-

minute set-up period must elapse before the

system can properly function.

ADVANCE TO FIELD:

PRCXGRAMFIELD:

ERASE FIELDS:

READ FIELD:

RESTORE FACTORY

PROGRAM SETTINGS:

EITCERZONE DESCRIP-

TION AND INSTALLER

MESSAGE PROGRAMMING

MODE :

SPECIAL MESSAGES

* + ADDRESS (e,go, 01, 1(J,21.,etc.),

* + ADDRESS, followed by data entries.

* + ADDRESS + *

(ody applies to Addresses 31 thru 34).

# + ADDRESS

*7 (see Factory Programming Table).

*3 (only relwent if 5137 Console is being used).

OC = OPEN CIRCUIT (no communication between the Console and the Control).

FC = FIELD CODE ERROR (program entry mistake, re-enter the data).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de instrucciones Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console