ADEMCO Alpha Vista Console Manual de instrucciones descargar pdf (Pagina 57)

Creating Custom Words:

Up to 5 installer-defined words can be added to the factory-provided vocabulary.

Each of the 5 “words”

can actually consist of several words, but bear in mind

that a maximum of 10 characters can be used for each word string. To create the

custom word or word string, proceed as follows:

10.

11.

Enter the programming mode.

Key

-3.

Now

key

created.

Key the

example,

creating

The following will be displayed: * ZN ??

to get into the mode which will allow the custcm words to be

The following will be displayed: * ED ?

number of the custcm word or word string to be created (O-4). For

if you are creating the first word (or word string), enter 0: when

the second word, enter 1, and so on.

A cursor will now appear

the beginning of the second line.

Use the 3 key to advance through the alphabet (numbers, symbols and special

characters are included). Use the 1 key to move back through the alphabet.

When you have reached the desired character, press the 6 key to select it.

The cursor will then move to the right, in position for the next character.

Repeat steps 5 and 6 to create the desired word (or words). Note that the 4

key can be used to move the cursor to the left if necessary, and that key 7

can be used to enter a blank (or to erase an existing character).

Press the 8 key to “save” the custan word(s) and return to the * ED ?

display. The custom word (or string of words) will be autc.maticallyadded to

the factory-provided vocabulary at the end of the group of words beginning

with the same letter.

Repeat steps 4 through 8 to create up to 4 additional custom words (or word

strings).

Press the * key to return to the * ZN ?? display.

Key

CREATING

Normally,

S9 to exit the programming mode.

A CUSTOM MESWE DISPLAy (ONLY USABLE ON 5137 ~NSOLES)

when the system is in the disarmed

state, the following display is

present on the Console.

****D1~****

READY TO ARM

Part or all of the above message can be modified

to create a custom installer

message.

For example,

****DISARMED**** on the first

line or READY TO ARM on the

second line could be replaced by the installation company name or phone nunber

for

service. Note that there are only 16 character spaces on each of the two

lines.

To create

a custom display message, proceed as follows:

Enter the programming mode.

Key

-3. The following will

be displayed: * ZN ??

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de instrucciones Pagina 57

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console