ADEMCO Alpha Vista Console Manual de instrucciones descargar pdf (Pagina 10)

ZONE EXPANSION

Zone expansion to an additional 8 zones is achieved by connection to No. 4208

Eight-Zone Expander by a single pair of wires providing both power and

signaling. Each of the 8 zones on the No.

4208 can be programmed from the

various types described in this manual that are available for use on the basic 9

zones,

with one exception.

There is no ability to support 2 wire smoke

detectors on any of the zones available in the No. 4208 Zone Expander.

The No.

4208 Zone Expander may be located near the No. 4140 or remotd.y from it. The

two wire run to it should utilize twisted pair wiring and should not be run in

close proximity to protected praises interccm wiring [at least a 3-inch (8 cm)

separation] .

For the maximum wiring run permissible to the zone expander for

various’ wiring gauges, see the Specifications Section relative to the No.

4208

Zone Expander later in this manual.

IMPORTANT :

In order to utilize the No. 4208 to obtain zones 10-17, this

product’s DIP switches must be set as follows:

0000

(as if set for sensor nunbers 113-120, as

cited in the instructions for the No. 4208)

Installation instructions for the wiring connections to the No. 4208 are

provided in a subsequent section entitled “WIRING TO No. 4208”.

4-DIGIT SECURITY CODES

Installer Code:

The instsller programs the Installer Code initially as part of the programming

procedure (see

mprogrming ‘he

Security Control”).

In this system, the

installer is considered to be user #1.

The installer code permits re-entry into

the programming mode (unless

*98 has been previously used to exit

the

programming mode) and also allows access

to the normal functions of the systen.

During initial programming, the installer also programs the Master security code

into the system. Open/Close reporting must be enabled for User # 1 for this code

to be operational.

[1[1[1[1

Installer Code (User #l), assigned during programming.

Installer exits programming mode with:

W39 (allows re-entry into programming mode with installer code).

*8 (does not allow re-entry to programming mode unless system is

first powered

down and then repowered). Installer code is

disabled when this exit is used.

Master Security Code:

The Master security code

can be used to assign up to thirteen secondary codes

(to users #3-#15): it can also be used to remove all secondary codes from the

system (individually).

The person to whom the Master code is assigned is

considered to be user #2.

In some applications

(canmercial installations, for

example), user #2 (with Master code) will be the main user of the systen (see

Application 1 on a following page).

In other applications (such as in an

apartment complex, for example),

user #2 (with Master code) may not be the

actual end user of the system (see Application 2 on a f~lowing Page).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de instrucciones Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console