ADEMCO Alpha Vista Console Manual de instrucciones descargar pdf (Pagina 58)

3. Key 00. The following will appear: * ED ??

40 Press the 5 key.

The following will appear:

****DI~****

READY TO ARM

A cursor will be present on the extreme left of the first line (over the

first “star”).

The 6 key is used to move the cursor to the right and the 4

key to move the cursor to the left.

Key 7 may be used to to insert spaces or

erase existing characters.

For example,

to replace

READY TO ARM with the message SERVICE:424-0177,

proceed as follows:

Press the 6 key to move the cursor to the right, and continue until the

cursor is positioned over the first location on the second line.

Press the 3 key to advance through the alphabet to the first desired

character (in this case, “S”).

Use the 1 key to go backward, when

necessary. When the desired character is reached, press 6. The cursor will

then move to the next position,

ready for entry of the next character (in

this

example,

lfEtl).

When the cursor reaches a position over an existing

character, pressing the 3 or 1 key will advance or back up frcm that

character in the alphabet.

Proceed in this manner until all characters in

the message have been entered.

6. To store this new display message in memory, press the 8 key.

Press the * key to return to the *

ZN ?? display. To confirm that the new

message has been stored in memory, press 00 and then press key 5. The new

message should be displayed.

8. Key *99 to exit the descriptor/programming mode.

TESTING THE SYSTEM

After installation is completed,

the Security System should be carefully tested.

With the System in the disarmed state, check that all zones are intact. If

DISARMED -

Press * to shuw faults (5137) or NOT READY (4137) is displayed,

press the * key to display the descriptors of the faulted zone(s). Restore

faulted zone(s) if necessary,

so that

****DISARMED***READY TO ARM (5137) or

READY (4137) is displayed.

2. Enter the security code and press the TEST key.

The external sounder (if

used) should sound for 3 seconds and then turn off (the system is operating

on the back–up battery only at this time).

Note 1.

The system will not enter the TEST mode if the battery voltage is

too low,

if the battery is not connected, or if any communication

messages are waiting to be transmitted.

Note

As a reminder that the system is in the TEST mode, the Console

will sound a single beep at 15-second intervals if no protection

zones are violated.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de instrucciones Pagina 58

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console