ADEMCO Alpha Vista Console Manual de instrucciones descargar pdf (Pagina 39)

SECONDARY ACK

*47

WAIT

SECONDARY

TRANSMISSION

FORMAT

*48

SINGLE MESSAGE

*49

TRANSMISSION WITH

CHECKSUM

VERIFICATION

SESCOA/lUDIONICS

*50

SKLECTION

DUAL REPORTING

*51

OPEN/CLOSE

*52

REPORTING ENABLE

BY USER CODE

COMMENTS :

Central station receiver

“Acknowledge”

wait time for secondary phone number.

Enter O (30 seconds) or 1 (60 seconds).

COMMENTS: Same options as Address *46.

Enter O (Ademco Low Speed), 1 (SESCOA/Radionics),

or 2 (Ademco High Speed).

COMMENTS: When selected, will send a verification

digit with the message to validate the message at

the receiver without having to send two message

rounds.

Enter O (NO) or 1 (YES).

NOTE : Selection applies to both primary and

secondary phone numbers.

COMMENTS: Enter O if Radionics format is to be

used with hexadecimal B-F reporting;

enter 1 if

SESCOA format is to be used with only numeric

reporting (O-9).

NOTE : Selection applies to both primary and

secondary phone numbers.

COMMENTS: If selected,

will send all reports to

both primary and secondary phone numbers.

Note: If dual reporting is desired and Ademco High

Speed format

is to be used at all, it must be

selected as both the primary and secondary

transmission formats.

Enter O (NO) or 1 (YES)

1 23 45 67 8

[1[1[1[1[1[1[1[1

COMMENTS: Enter O (disable) or 1 (enable)

Determines which user code will send open/close

reports. User #7 must be enabled if open/close

reporting is desired for keyswitch arming or close

reporting is desired for “Quick Arm” and “Power

Up” arm.

Note:

User 1 must be enabled to permit use of

installer code to enter Programming mode.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO Alpha Vista Console Manual de instrucciones Pagina 39

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Alpha Vista Console