ADEMCO Alpha Vista Console Manual de instrucciones Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 68
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
CONFIRMATION OF
*16
ARMING DING ENABLE
AC Pm LOSS
SC%JNDING
NOT USRD
NOT USED
NOT USED
DISABLE
FIRE TIME-OUT
*17
*1~
*19
*20
*21
FIRE INDICATION
*22
AT DISPLAY
MULTIPLE ALARMS
*23
DISABLE TAMPER
DETECTION IN
EXPANSION ZONES
10-17
*24
DISABLE DURESS
*25
REPORTING IN ADEMCO
HIGH SPEED FORMAT
[1
COMMENT S:
Enter 1 to enable 1/2 second external
alarm sounding at the end of exit delay #1 and O
to disable the ‘tding”.
[1
COMMENTS: Enter 1 to enable this feature. Results
in rapid beeping at Console when AC power is lost;
otherwise, enter O.
[0] ~fl BE ZERO
[0] MUSTBE ZERO
[01 MUST BE ZERO
[1
COMMENTS: Disables the
for any zone designated
fire sounding continues
(required for usage in
Household Fire). Enter O
out).
[1
sounder time–out feature
as a fire zone so that
until the system is reset
accordance with UL985,
(time–out) or 1 (no time-
COMMENTS: Enables a display of FIRE.
Enter 1 to
enable; otherwise enter O (only zone number and/or
descriptor displayed).
[1
COMMENTS: Enables the system to permit multiple
audible alarms from a protection zone during one
armed interval (as opposed to only one alarm).
Enter O (only one alarm) or 1 (multiple alarms,
but not more frequently
than allowed by alarm
time-out).
Selection has no impact on the number
of communication messages transmitted.
[1
COMMENTS: Only applicable if No. 4190WH RPMs are
used to provide expansion zones.
Enter 1 to
disable tamper detection (disables tamper
detection in 4190WH or tamper detection is not
applicable because other devices are used to
provide expansion zones). Enter O to enable tamper
detection (opening of the 4190WH case). For fire
zones, tamper is &ways active, independent of the
entry in this field.
[1
COMMENTS: Only applicable if Ademco High Speed
Format is selected. Enter 1 to disable duress
reporting or O to enable duress reporting.
34
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 67 68

Comentarios a estos manuales

Sin comentarios