ADEMCO Alpha Vista Console Manual de instrucciones Pagina 38

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 68
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 37
DIAL TONE PAUSE
*42
DIAL TONE
DETWXION
RING DETECI!ION
[1
COMMENTS: This feature determines the wait time
for dial tone detection before dialing will
commence,
if detection does not take place.
Enter single digit, O (5 seconds), 1 (11 seconds)
or 2 (30 seconds).
*43
[1
COMMENTS:
Determines whether true dial tone
detection is used,
or whether just delay before
dialing (same as programmed in Address *42) is
used.
The latter may be necessary in high–noise
environment Telco networks where noise can be
confused with did tone and premature dialing
results.
Enter 1 (Dial Tone detection) or O (Dial
Tone Detection disable).
[1[1
COMMENTS:
Only applicable if central station
initiated downloading will be used. Enter 00 to
disable ring detection.
Enter 01-14 for ring
counts of 1-14. Enter 15 to select mode that gets
around telephone answering machines connected to
the same phone line.
In the latter mode, the
system upon hearing one ring followed by nothing,
will not answer but will ready itself to pick up
the next incoming call received within the next 30
seconds on the first ring (the downloader calling
again) .
PRIMARY A(X WAIT
*45
[1
COMMENTS: Central Station receiver
“Acknowledge”
wait time for primary phone number.
Enter O (30 seconds) or 1 (60 seconds).
PRIMARY
TRANSMISSION
FORMAT
*46
[1
COMMENTS:
Permits selection between Ademco Low
Speed format, SES02A/Radionics, or Ademco High
Speed format.
Enter O (Ademco Low Speed), 1 (SESCOA/Radionics),
or 2 [Ademco High Speed – Traditional for up to 12
(all 17 if non–unique reporting is acceptable)
wired zones
and 4+2 DTMF for up to 17 wired
zones] .
Note:
If Traditional Ademco High Speed reporting
is selected,
the Non-Alarm reports desired must be
selected in Addresses *40, *67 and *68 (any non-
zero code may be used).
38
Vista de pagina 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 67 68

Comentarios a estos manuales

Sin comentarios