ADEMCO 5130XM Manual de instrucciones descargar pdf (Pagina 95)

PROGRAMMING THE SYSTEM

- 0. PROGRAMMING ZONE DESCRIPTIONS -

(513OXM 8i 5137 CONSOLES ONLY)

INTRODUCTION

A user friendly English language descriptiorViocation of protection zones,

keypad panics, polling loop shon and the first 4260 supenilsion faults can be

programmed into the system (up to 59 descriptions). Each description can be

composed of a combination of words (up to a maximum of 3) that are selected

from a vocabulary of approximately 220 words stored in memory (a complete

list of all words in this vocabulary Is provided at the end of this section. in

addition, up to 5 installer-defined words can be added to those already in

memory. Thus, when an alarm or trouble occurs in a zone, an appropriate

description for the location of that zone will be displayed at the console. in

addition, an installer’s message can be programmed which will be displayed

when the system is “Ready’ (ex. THE PETERSON’s).

ENTERING ZONE

DESCRIPTIONS

1. Enter programming mode as described previously.

2. Key ‘93. The following will be displayed:

l ZN

When in thii mode, the console keys perform the following functions:

[3] &~~s both alphabet and actual words in ascending alphabetical

[l] Scrolls both alphabet and actual words in descending alphabetical

order.

[6] Toggles between alphabet and actual word list.

16) Saves the zone description in the system’s memory.

[#] # plus zone number will display the description for that zone.

3. Key ‘01 to begin entering the description for zone 1, (key ‘02 for zone 2,

‘03 for zone 3 etc.). The following will be displayed:

l ZN

01 A

Note that the first letter of the alphabet appears after the zone number,

and that the zone number. is automatically included with the proposed

description.

4. Select the first letter of the desired description‘ (note that *A” is already

displayed). Use key 131 to advance through the alphabet and key [l] to go

backward. For example, assume the desired description for zone 1 is

BACK DOOR. Press key (31 repeatedly (or hold down the key) until ‘B

appears; then press key (61. to display the first available word beginning

with B. Repeatedly press key [3] to advance through the available words

until the word BACK is displayed. Press key [l] to move backward

through the word list.

5. For selection ot the second word (DOOR), press key IS]. “A” will now be

displayed again after the first word selected . Press key 13) until the

desired first letter of the second word appears (in this example,

D”).

Then press key [6] to display the first available word beginning with ‘D’.

Press key [3] repeatedly until the desired word (DOOR) appears.

6. If you wish to add a third word (provided there is sufficient space for if in

the display), repeat step 5 for that word.

7. When ail desired words have been entered, press key [S] to store the

description in memory.

6. To review the zone descriptions, key [#I] plus zone number

(e.g., #Ol). To edit zone descriptions, key [‘I plus zone number (e.g.. ‘01)

9. To exit the zone description mode, key ‘99.

NOTE: Alpha descriptor entry can be accomplished locally at the 5137

console or remotely using a 4130PC Downloader.

ADEMCOQ VISTA XM SERIES TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 158 159

Comentarios a estos manuales

Sin comentarios

ADEMCO 5130XM Manual de instrucciones Pagina 95

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 5130XM