ADEMCO 5130XM Manual de instrucciones descargar pdf (Pagina 52)

MOUNTING PROCEDURES

.-.

FLUSH MOUNTING

WlTH TRIM RING

lf a “rough-in’ ring (4133) has been previously installed in the wall (during new

construction; see Diagram 35) disregard step 1 and proceed to step 2, since

the required opening for the console is already present. If a wall plate (4136)

is installed over the rough-in ring, remove the plate to expose the opening.

Note: The four mounting tabs on the right-hand side of the 4133 rough-in

ring must be broken off before flush mounting can be performed.

1. Cut out a 4-314’ high by 6” wide opening in the wall between studs, no

less than 1-l/2g from either stud. See Diagram 34 (A). Use the template

provided to mark the cut-out.

2. Insert the four l-1/2’ long #6 screws through the mounting holes in the

supplied Trim Ring and then attach the four metal securing clips, as

shown in Diagram 34 (B). Use only two or three tums of each screw,

allowing the metal clips to hang freely. The clips must not protrude

beyond the sides of the Trim Ring or you will not be able to install the Trim

Ring into the cutout in the next step.

3. Install the trim ring into the opening in the wall with the hinge clasps to the

right, as in Diagram 34 (D). Making sure the trim ring is straight, tighten

each clip screw, making sure that the attached clip slides down into its

guide track. As each screw is tightened, the clip will be drawn up against

the wall (see Diagram 34 (C)). Tighten each screw until the trim ring is

securely held against the wall. DO NOT OVERTIGHTEN.

4. Referring to Diagram 34 (D). install the Console as follows: engage the

hinge clasps on the trim ring with the notches located in the back (right-

hand side) of the Console’s front panel. Swing the left side of the panel

toward the trim ring (the panel will pivot on the hinge clasps), and press

firmly until the panel “snaps. closed.

5. Use the panel securing screw (supplied with the Console) to secure the

left side of the panel, as shown in Diagram 34 (D). Insert nameplate into

the recessed area to cover the securing screw (see Diagram 33).

.f---.

INSERT NAMEPLATE

INTO RECESSED

AREA (COVERS SCREWI

SECURING

SCREW

Diagram 33. INSERTING THE NAMEPLATE

.-.

ADEMC04 VISTA XM

SERIES

TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 158 159

Comentarios a estos manuales

Sin comentarios

ADEMCO 5130XM Manual de instrucciones Pagina 52

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 5130XM