Ski-ION VIII
SYSTEM OPERATION
SECTION VIII
57
- A. SECURITY ACCESS CODES -
The VISTA XM System allows up to 22 security access codes to be assigned,
each identified by a user ID number. These codes are used to perform
system functions. In addition, the system can be programmed to send
open/close reports which identify the user by access code ID number (15
maximum for tmcfftional formats).
INSTALLER’S CODE
(USER #l)
The installer programs the Installefs Code initially as part of the programming
procedure (see PROGRAMMING THE SYSTEM), and this code is the only
code that permits re-entty into the programming mode (unless ‘98 has been
previously used to exit the programming mode, see below). The Installers
Code can also be used to perform normal system functions, but cannot
assign temporary codes.
The system also provides an Installer Code lock-out feature, which prevents
the use of the Installers Code from re-accessing the Programming mode after
the initial programming. This feature is activated by pressing ‘98 to exit
Programming mode. The only way to access Programming mode once this
feature is activated, is by powering down the system and powering up again,
and then pressing both the
l
and # keys at the same time within 30 seconds
of power up. fl m-access to Programming mode using the lnstalleh Code is
desired after initial programming, then exit Programming mode by pressing
‘99.
NOTE: As shipped from the factory, an initial Installer’s code is pre-
programmed, and can be changed by the installer to any code desired (field
‘00). me pre-programmed codes are as follows:
4130XM I 4-1-3-O
4140XM w 4-l -4-O
5130XM = 5-1-3-O
MASTER CODE
(USER t2)
The Master Code is the code intended for use by the primary user of the
system when performing system functions, and is a permanent code. The
factory default master code is l-2-34. For addiiional security. the Master
Code can be used to assign up to twenty temporary codes, which can be
used by secondary users of the system who do not have a need to know the
Master Code (supervisors, employees, cleaning personnel. tenants, etc.).
Each user (ID number 0322) can be assigned a temporary code which can be
individually eliminated or changed at any time.
The installer is considered user 1. The person to whom the Master code is
assigned is considered user 2. In some applications (commercial installations,
for example), user 2 (with Master Code) will be the primary user of the system.
In other applications, user 2 (with Master Code) may not actually be the end
user of the system (apartment building owner, for example).
Note that the Master Code (assigned to user 2) and all temporary codes can
be used Interchangeably when performing system functions (a system armed
with a useb temporary code can be disarmed with the Master Code or
another use6 temporary code).
Temporary user 3 also has the ability to assign and eliminate other temporary
user codes (users 4-21). User 22 can only be assigned or changed by user 2.
ADEMCO’s VISTA XU SERIES TECHNICAL REFERENCE MANUAL
.
WWW.DIYALARMFORUM.COM
(39 paginas)
(173 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales