ADEMCO 5130XM Manual de instrucciones descargar pdf (Pagina 117)

116

TROUBLESHOOTING

- D. WIRELESS -

“88” or “90” appears

in console display

and rapid beeping

occurs

The receiver is not receiving any signals from any of the transmitters in

the system. .An “68. is for the 2nd 4280; a “90’ is for the 1 st 4280. These

displays are enabled by assigning a zone response type in program fields

1’06, and 1’09. The recommended response is either zone type 05 or

07 (see

the

ZONE TYPE DEFlNlTlONS section. wireless installation.

Check that the antenna is installed properly and is not shorted to any

metal object, refer to WIRELESS EXPANSION section for details.

. Check that the transmitters are powered up with fresh 9 voit batteries.

Check that the house ID’s match between transmitters and the 4260.

Determine if anything is blocking transmission to the 4280 (ex: metal

cabinets or shetves, etc.)

Remove the 4280% cover and put the system in the test mode, then see

if the transmitters check-in. If not, move the 4260 to another location and

test again.

“89”

or “9,”

appears in console

display and rapid

beeping occurs

The 4280 is not responding to the Control panel. An ‘89’ refers to the

second 4280 and a 91’ refers to the first 4280.

Check that the 4280’s cover is on and the magnet is in close proximity to

the reed switch.

. Check that the polling bop is attached to the 4280.

Determine that the total current draw on the polling loop is not more than

64mA. See SPECIFICATIONS. If the draw does exceed 64mA, install a

..-.

4197 loop extender module as described in the WIRELESS

EXPANSION section, or power the 4280 from auxiliary power, as

described.

Check that the polling loop length is in agreement with the

recommended wire gauge. If the length exceeds what is recommended,

install a 4197 loop extender module as described in the WIRELESS

EXPANSION section.

Zones, not pro-

* Check program fields l 02 through ‘05, and 1’01 through 1’05’to make

grammed in the

sure .all unused zones are 00s.

system, are indicating

Check program fields 1’18 through 1’25 to make sure that all non-RF

“CHECK” conditions

zones are 0s.

Zones indicating

“NOT READY” condition,

Put the system in the SNIFFER MODE for at least 2 hours. to see if

but transmitter contact

another system in the area is using the same house ID. If so, change this

loop is intact

system’s house ID number at the 4280 and at all transmitters.

Make sure zones In question are selected as RF in fields 1’18-1’25.

.-.

ADEMCO’s

VISTA

XM SERIES TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 158 159

Comentarios a estos manuales

Sin comentarios

ADEMCO 5130XM Manual de instrucciones Pagina 117

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 5130XM