ADEMCO 5130XM Manual de instrucciones descargar pdf (Pagina 24)

SYSTEM CONFIGURATION (ZONES)

GENERAL

INFORMATION

4171XT-XM

INSTALLATION

4152LMB

INSTALLATION

- B. ZONE EXPANSION MODULE-

(Required for zones 10 through 64)

To expand the system using a P-wire Polling Loop an&or wireless devices, a

4171XT-XM dialer board, and a 4152LMB Loop Module must be installed as

shown below. (The 4171 XT-XM is factory installed in the 4140XM.)

Remove the Control’s back cover and discard. Insert three small standoffs

(supplied) into the three holes on the Control board (marked A. B & C on the

diagram), pressing each until they ‘snap’ into place. Insert the 1Spin male-to-

male adapter (supplied) into the interface socket pin holes on the underside

of the Dialer board as shown.

Guide the adapter pins into the pin holes on the Control bvoard, while

aligning the standoffs with their respective holes in the Dialer board.

Be sure

the adapter pins are properly entering the Control board holes, and press

down until the pins are fully seated and the standoffs “snap” into place.

Note the 8 square-shaped connector pins on’the dialer board. Position the

4152LMB board over that board so that these pins engage the mating

sockets (header) on the underside of the 4152LMB. Press the 4152LMB

down until the pins are fully seated. Secure the No. 4152LMB by means of 3

screws (supplied).

Wires from the 4208 Zone Expander, RPMs, and 4280 are connected to

Terminals 1 8 2 on the 4152LMB. For information regarding polling loop or

wireless expansion, refer to those sections which follow.

I . .

INSTAIUNG DIALER BOARD

INSTALLING LOOP MOOULE

Dlagmm 4.4152LMB INSTALLATION AND WIRING

ADEMCO’s VISTA XM SERIES TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 158 159

Sin comentarios

ADEMCO 5130XM Manual de instrucciones Pagina 24