ADEMCO 5130XM Manual de instrucciones descargar pdf (Pagina 34)

SYSTEM CONFXCVRATXON (ZONES)

USING TWO

RECEIVERS TO

For installations where the area to be protected goes well beyond the 200

range of the system, or the building configuration preventsgetting the rated

INCREASE COVERAGE

range in ail paths to transmitters, a second receiver can be installed. The first

4280 is bcated at one end of the premises and the second 4280 at the other

with both 4280s connected to the same P-wire polling loop.

AREA 12

Dlsgmm 12. TWO WIRELESS RECEIVERS TO INCREASE COVERAGE

ADVISORIES

1. if dual 4280s or 4280-8s are used:

A. Both must be at least 10 feet from each other, as well as from the

,-.

vista XM Control panel and remote consoles.

B. One of the 4280s or 4286-8s must be powered from Aux. power

(see SPECIFICATIONS).

C. The house IDS must be the same.

0. Using two Receivers &es not increase the number of transmitters

the system can support (62 transmitters, plus a wireless keypad).

2. Follow the chart below for max. polling loop runs:

V22 gauge @65fY max

320 gauge @95V max

‘#I8 gauge @lSOO’ max

‘#16 gauge @ 2400’ max

Note: Twisted pair recommended for ail normal runs.

IMPORTANT: The maximum combined polling loop run is 4000’. If using

shielded wire, the maximum is 2000’.

CAUTION:

if an intercom system is being used, the polling loop wires must

be as far from the intercom wiring as possible (minimum 6’). if this spacing

cannot be accomplished. shielded wire must be used. If this is not done,

interference on the intercom system might occur! Also note that the

maximum total wire supported is cut in hall when shielded wire is used.

ADEXCO’s VISTA XM SERIES TECHNXCAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 158 159

Sin comentarios

ADEMCO 5130XM Manual de instrucciones Pagina 34