ADEMCO VISTA-250FBP Guia de preparacion descargar pdf (Pagina 98)

VISTA-128FBP/VISTA-250FBP Installation and Setup Guide

7-4

Scheduled Download (For Burglary Use Only)

The VISTA-128FBP/VISTA-250FBP can be

programmed to periodically and automatically call the

downloader. When this option is set up, the system will

call the downloader at a scheduled time. Once the

connection is established with the modem, the

downloader controls which functions are performed

(download, arm, upload event log, etc.).

It should be noted that Compass always

uploads before performing a download

session.

The programmable options for the scheduled download

are located in the #93 Menu Mode in the Programming

Guide under the main menu prompt Scheduled Check-

in.

The options are as follows:

• Check-in interval (weekly, monthly quarterly,

yearly)

• Quarter of the year (if quarterly is selected)

• Month of the year (if monthly, quarterly, or yearly

is selected)

• Day of the month (if monthly, quarterly, or yearly

is selected)

• Day of the week (if weekly is selected)

• Time of day

Refer to the #93 Menu Mode in the Programming Guide

for sequence of the prompts.

Direct-Wire Downloading

The VISTA-128FBP/VISTA-250FBP can be downloaded

without using a modem or telephone line by using a

4100SM Serial Module and Compass Downloading

Software. The direct-wire downloading connection is to

be temporary, and is not part of the permanent

installation. Direct-wire downloading is meant as a tool

for the installer during the installation process.

The connections between the control and

the 4100SM are different than those shown

in the 4100SM Installation Instructions. See

Figure 7-1

for the correct connections. In

addition, in place of the green wire, referred to

in step 2 of the “IN CASE OF DIFFICULTY”

section of the 4100SM Instructions, use the

violet wire instead.

Connector J2 on the main PC board (see the Summary

of Connections diagram on the inside back cover of this

manual) is intended to be interfaced to either a local

serial printer (see Event Log Connections in SECTION

3 Installing the Control) or a computer. Make

connections to a computer as shown below. Note that

the violet wire connection for a computer differs

from that used when connecting a serial printer.

NOTE: The 4100SM Serial Module must be removed

from the J2 Header at the completion of downloading.

Figure 7-1: Direct-Wire Downloading Connections

Telco Handoff

Telco handoff is another method of getting on-line with the downloader. The installer or customer enters the User Code

+ [#] + [1], while on the phone line with the computer’s modem phone line. The customer will get cut-off and the panel

and download computer will establish a connection.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 135 136

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-250FBP Guia de preparacion Pagina 98

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-250FBP