ADEMCO VISTA-250FBP Guia de preparacion descargar pdf (Pagina 70)

VISTA-128FBP/VISTA-250FBP Installation and Setup Guide

5-6

FIELD TITLE and DATA ENTRIES EXPLANATION

*54

Unattended Mode

0 = disable

1 = enable

If enabled, the installer may initiate an unattended download session by

entering Code #89.

NOTES:

Must be set to “0” for UL installations (downloading is not UL Listed).

The following fields must be programmed first: primary subscriber account

number – field *32; primary phone number – field *33; downloader phone

number – field *35. Or you can go into the Unattended Program Mode, from

normal operating mode, by entering Installer Code + [#] + [8] + [9].

*56

Dynamic Signaling Delay

Enter 00-15 times 15 seconds.

Select the time the panel should wait for acknowledgment from the first

reporting destination before it attempts to send a message to the second

destination (first and second destinations are determined in field

✳57).

NOTES: A minimum of 45 seconds is recommended when the Communicator

is set to be the primary report path. If the delay is short (30 seconds or less),

the communications device does not have enough time to sent the

acknowledgement back to the panel, therefore the report would be sent out

via the dialer.

If the acknowledgment is received before the delay time expires, no message

is sent to the second destination.

*57

Dynamic Signaling Priority

0 = Primary Dialer

1 = Communicator

Select the initial reporting path for central station messages.

*58

Communicator Central Station #1

Category Enable

0 = disable

1 = enable

This field has six entries as follows: Alarm, Trouble, Bypass, Open/Close,

System, and Test. If enabled, the reports are sent to the primary subscriber ID

of the Communicator.

*59

Communicator Central Station #2

Category Enable

0 = disable

1 = enable

This field has six entries as follows: Alarm, Trouble, Bypass, Open/Close,

System, and Test. If enabled, the reports are sent to the secondary subscriber

ID of the Communicator.

*77

Auto Trouble Restore

0 = disable

1 = enable

If enabled, each trouble and supervisory condition automatically clears the

keypad display and stops the keypad beeping when the zone returns to a

“ready/normal” state. This applies to ALL trouble and supervisory types. The

system also sends the Trouble/Supervisory Restore report to the central

station, if programmed.

If a partition has more than one trouble/supervisory condition present at the

same time, the system automatically clears the keypad display of each zone

as it restores, but the keypad continues to beep until all the zones restore.

NOTE: If this option is set to 0 (disable) then the operation is that restore

reports will be sent to the CS when the actual restoral on the zone occurs,

however the keypad display will remain showing the condition until a valid

code is entered.

Must be 1 for Commercial Fire installations.

*79

Zone Type Restores for Zone

Types 1-8

0 = disable

1 = enable

This field has eight entries, one for each zone type. Select the zone types that

will send Restore reports.

*80

Zone Type Restores for Zone

Types 9, 10 & 14

0 = disable

1 = enable

This field has three entries, one for each zone type. Select the zone types that

will send Restore reports.

Restores must be set to “1” for Commercial Fire installations.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 135 136

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-250FBP Guia de preparacion Pagina 70

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-250FBP