ADEMCO VISTA-250FBP Guia de preparacion descargar pdf (Pagina 38)

VISTA-128FBP/VISTA-250FBP Installation and Setup Guide

3-16

Compatible Polling Loop Devices

Model Number Type

4297 Extender Module

4208SN 8 Zone V-Plex Interface

4208SNF 8 Zone V-Plex Class A Interface

269SN V-Plex Holdup Switch

5192SD Photoelectric Smoke Detector Devices

5192SDT Photoelectric Smoke Detector w/Heat Detector

5193SD Photoelectric Smoke Detector Device

5193SDT Photoelectric Smoke Detector w/Heat Detector

4101SN Serial Number Single-Output Relay Module

4208U Universal 8-Zone Expander

4959SN Aluminum Overhead Door Contact

4193SN Serialized 2-Zone Expander

4293SN Serialized 1-Zone Expander

4190SN Serialized 2-Zone Expander

4190WH DIP Switch 2-Zone Expander

998MX Serialized PIR

Quest 2260SN Serialized PIR

IS2500SN V-Plex PIR

V-Plex VSI V-plex Short Isolator

NOTE: If using the new 5193SD/SDT V-Plex smoke detectors (or older 5192SD/SDT with the maintenance DIP sw enabled)

the "Smart" option must be selected in zone programming or when they

enroll unpredictable results may occur if the

smoke goes into a High Sens or Low Sens condition.

To install polling loop devices, perform the following steps:

Step Action

1 Select devices from the list of compatible devices shown previously.

2 Set the DIP switches in the device (if required). Refer to the device’s instructions for the DIP Switch Tables.

3 Mount each device in the desired location. Refer to the device’s instructions.

Run wires from the control panel to each device on the polling loop (see Figure 3-15). No individual wire run

may exceed the lengths shown in the following table.

Maximum Polling Loop Wire Runs

Wire Gauge Max. Length

#22 gauge 650 feet

#20 gauge 950 feet

#18 gauge 1500 feet

#16 gauge 2400 feet

5 Wire each device to the polling loop, making sure of the correct polarity (refer to the device’s instructions).

NOTE: If you are using serial number devices, and intend to enroll each device through the keypad

automatically, wire no more than 25 of these devices to the control at a time. Then power up and

program them before connecting the next 25. Leave previously enrolled devices connected.

If you intend to manually enter the serial numbers through the keypad or through Compass downloading

software, all the devices may be connected before powering up to program.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 135 136

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-250FBP Guia de preparacion Pagina 38

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-250FBP