ADEMCO 4140XMPT2 Manual de usuario descargar pdf (Pagina 64)

– 64 –

Section 4. PROGRAMMING WITH #93 MENU MODE

General Information NOTE: The following fields should be preset before beginning:

1*26 First RF Expander; 1*27 Second RF Expander; 2*00 Number

of Partitions; 1*32 receiver type. In addition, receivers should be

programmed via Device programming.

After programming all system related programming fields in the usual way, press

#93 while still in programming mode to display the first choice of the menu driven

programming functions, which are as follows:

ZONE PROG?

1=Yes 0=No

For programming the following:

• Zone Number

• Zone Response Type

• RF Zone?

• Right Loop Zone?

• Partition Number for Zone

• Dialer report code for zone

SERIAL PROG?

1=yes 0=no

For entering 5800 transmitter & serial number polling

loop device serial numbers into the system.

ALPHA PROG?

1=yes 0=no

For entering alpha descriptors for the following:

• Zone Descriptors

• Installer's Message

• Custom Words

• Partition Descriptors

• Relay Descriptors

DEVICE PROG?

1=yes 0=no

For defining the following device characteristics for

addressable devices, including consoles, RF

receivers (4281/5881) and 4204 output relay

modules:

• Device Address

• Device Type

• Device's Home Partition

• Console Options

RELAY PROG?

1=yes 0=no

For defining output relay functions.

Press 0 (NO) or 1 (YES) in response to the displayed menu selection. Pressing 0

will display the next choice in sequence. Refer to the ZONE PROGRAMMING

section for instructions for programming zone characteristics, the DEVICE

PROGRAMMING section for instructions for programming addressable devices,

and the ALPHA PROGRAMMING section for programming alpha descriptors. The

following is a list of commands used while in the menu mode.

#93 Menu Mode Key Commands

#93 Enters Menu mode

[Q] Serves as ENTER key. Press to have console accept entry.

[#] Backs up to previous screen.

0 Press to answer NO

1 Press to answer YES

01-09 All entries are 2-digit entries.

00 Escapes from menu mode, back into field programming mode.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 131 132

Comentarios a estos manuales

Sin comentarios

ADEMCO 4140XMPT2 Manual de usuario Pagina 64

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4140XMPT2