ADEMCO 4140XMPT2 Manual de usuario descargar pdf (Pagina 28)

– 28 –

OUTPUT CONTROL (4204 Relay Module/X-10 Devices)

General Information The 4140XMPT2 supports up to 16 relay outputs. These outputs may consist of

relay outputs from the 4204 output relay module (4 relay outputs per module) or

X-10 device outputs. Outputs can be activated and deactivated by

predetermined events such as turning on lights in the event of an alarm condition

and/or closing a fire door in the event of a fire alarm condition. Refer to the

PROGRAMMING GUIDE for instructions on programming relay options.

There are many different uses for relays, some of which are shown at the end of

this section.

4204 Relay Module The 4204 Relay Module has 4 form C (normally open and normally closed

contacts) relays. Each relay can be used independently for different functions.

The 4204 is wired to the control's console terminals 6-9. Use standard 4-

conductor twisted cable (for long wire runs) or the connector supplied with the

4204. Each 4204 should be home run back to the panel. The maximum wire run

length from the panel to the 4204 must not exceed:

Wire Gauge Maximum Length

#22 (0.64mm) 125 feet (38m)

#20 (0.8mm) 200 feet (61m)

#18 (1.0mm) 300 feet (91m)

#16 (1.3mm) 500 feet (152m)

The 4204's DIP switch must be set for a device address and that address must be

enabled in the control's Device Programming mode. (Note that some early units

have only 4 DIP switches.)

Program the output relays using the control's *93 Menu Mode. Refer to the

PROGRAMMING GUIDE for details.

4300 Transformer & X-10

Devices

When using X-10 devices, the 4300 60Hz/110VAC transformer must be used

instead of the 1361 transformer shown on the Summary of Connections

diagram. The 4300 provides AC power to the panel and relays signals from the

panel through the premises AC wiring to X-10 devices.

Run a 3-conductor cable between the 4300 interface and the panel. Splice this

cable to a 4142TR cable as shown in the diagram below. Note that the white and

yellow wires of the 4142TR must be spliced together.

X-10 devices plug into standard AC outlets and can be used to perform various

functions. Be sure to set the proper house and unit IDs when using X-10 devices.

UL NOTE: X-10 devices and the 4300 are not UL Listed for fire or burglary

functions and are intended for home automation.

123456789

GROUND

OUT 6

IN 2

GROUND

IN 3

GROUND

OUT 5

J8 CONNECTOR

BLACK

BLUE

BROWN

GREEN

RED

WHITE

YELLOW

GRAY

VIOLET

4142TR CABLE

TB1

-1

TB1

-30

TB1

-2

Earth

Ground

Sync

Data

Com

4300 TRANSFORMER/INTERFACE

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 131 132

Comentarios a estos manuales

Sin comentarios

ADEMCO 4140XMPT2 Manual de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4140XMPT2