ADEMCO 4140XMPT2 Manual de usuario descargar pdf (Pagina 100)

– 100 –

Time-Driven Event

Programming

(continued)

01 ACTION ?

none 00

Enter the action code for the desired action for this event

number from the list at the left. This could be an output

command, an arming command, or any other time-driven

event. Press * to accept the entry and display the

appropriate action specifier prompt as follows:

Action Codes:

01=relay on

02=Relay Off

03=Relay Pulse

04=Relay Pulse XX minutes

05=Relay Pulse YY seconds

Actions 01-05

Enter the relay number and press

* to accept entry. The Time

Window ? prompt appears.

01 RELAY # ?

06=Relay Group On

07=Relay Group Off

08=Relay Group Pulse

09=Relay Group Pulse XX minutes

10=Relay Group Pulse YY seconds

Actions 06-10

Enter the relay group number and

press * to accept entry. The Time

Window ? prompt appears.

01 RELAY GRP # ?

20=Arm-Stay

21=Arm Away

22=Disarm

23=Force Arm Stay

24=Force Arm Away

40=Enable Open Window by part

41=Enable Close Window by part

Actions 21-24 and 40-41

Enter the partition to which the

action applies. Enter 0 to select all

partitions. Enter a partition number

again to deselect it. Press * accept

entry. The Time Window ? prompt

appears.

PART? 12345678

HIT 0-8 X X

30=Auto bypass - Zone list

31=Auto unbypass - Zone list

Actions 30-31

Enter the zone list number which

contains the zones to be

bypassed or unbypassed. Press *

to accept entry. The Time Window

? prompt appears.

01 ZONE LIST ?

ENTER 1-8 1

42=Enable Access Window for

Access group(s)

Action 42

Enter the group number to which

the time window will apply. Press *

to accept entry. The Time Window

? prompt appears.

GROUP ? 12345678

HIT 0-8 X

01 Time Window ?

00:00 00:00 01

Enter the time window number (01-20) for which this

timed event is to occur. As the number is keyed in, the

actual time that has been stored for the window will be

displayed. Press the * to continue.

01 Active time ?

Enter the activation code number from 01-04 (listed

below). As the number is keyed in, the activation time will

be displayed. The choices are:

1. Trigger at the start of the window

2. Trigger at the end of the window

3. Take effect only for the duration of the window

4. Trigger at both the start and the end of the window.

Example - coffee break buzzer

Press the * key when the desired choice is showing.

Days ? MTWTFSSH

Hit 0-8 x x

The system will then ask for which days the event is

to be activated. Press 0 to toggle all days on or off or

else press keys 1-8 to toggle the letter x under the

day on or off (Monday = 1, Holiday = H = 8 ).

When all entries have been made, the TIMED

EVENT # prompt is displayed again. Repeat the

procedure for each timed event required by the

installation.

When all timed events have been programmed, enter 00 at the TIMED EVENT

prompt to quit this set of menus.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 131 132

Comentarios a estos manuales

Sin comentarios

ADEMCO 4140XMPT2 Manual de usuario Pagina 100

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4140XMPT2