ADEMCO 4140XMPT2 Manual de usuario descargar pdf (Pagina 43)

Mode Features For Each Arming Mode

Exit

Entry Perimeter Interior

Delay

Armed Armed

AWAY Yes Yes

Yes

STAY Yes

Yes Yes No

INSTANT Yes No

Yes

MAXIMUM

Yes No

Yes

Access Control If programmed, one relay maybe used for access oontrol. To activate this relay,

the user enters his user code + [0]. The relay will pulse for 2 seconds.

Delay Closlng Time If open/close schedules are used, end users can manually extend the closing

window by up to

2 hours. This is useful if a user must stay on the premises later

than usual. User must have authority level of manager or higher.

To extend the closing window, enter user code + # +82, The following will be

disDlawd.

EE!EI

Enter the number hours, 1 or 2, by which the end of the

closing window should be delayed. Note that the delay is

from the scheduled closing time, not from the current time.

Press

● to acoept entry and exit this mode. Press # to exit this

mode without changes.

The system will send a “Schedule Changed” message to the

central station when the closing window is delayed.

Important: The delay cannot be reduced onoe it is set. It can

only be increased. This is to prevent the user from deleting

the delay after the normal window expires, thereby missing

the end of the window.

Partition “GotoM Each console is assigned a default partition for display purposes, and will show

Commands

only that partition’s information. To see information for another partition, or

perform system functions in another partition, use the GOTO command (code+

~] +pattition number O-8). The oonsole will remain in the new partition until

directed to go to another partition, or until 120 seconds has elapsed with no

keypad activity.

View Capabllltles Of A

The console will display the partitions that user is authorized for, the user

User

number, and the authority level for all partitions authorized. Enter oode + [X] +

[x]. The user’s capabilities in each authorized partition will typically be disp~y~

as follows:

The user’s Open/Close report capability is shown by the dot following the

authority level. If Open/Close is not enabled for a user, the dot will not appear.

Viewing Downloaded

Users may occasionally receive messages on the console display from their

Messages

installation oompany. When this occurs, the console will display “Message. Press

Ofor 5 sees.”. Instruot the user to press and hold the Okey to display the central

station’s message. Note that the system must be in the READY state to view

these messages.

Using The Built-in

An abbreviated User’s Manual is stored in the system’s memory, and can be

Userls Manual particularly useful to the end user if the printed Usets Manual is not mnveniently

accessible when the user needs to perform a seldom used and unfamiliar system

procedure. The Built-in Usets Guide is displayed by simply pressing any of the

function keys (e.g., OFF, AWAY, STAY, MAXIMUM, BYPASS, INSTANT, CODE,

TEST, READY, #, and CHIME) for approximately 5 seconds and then releasing it.

Abbreviated instructions relative to the key that has been pressed will then be

displayed (2 lines of text are displayed at a time). This function operates in either

the armed or the disarmed state.

-43-

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO 4140XMPT2 Manual de usuario Pagina 43

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4140XMPT2