ADEMCO 4140XMPT2 Manual de usuario descargar pdf (Pagina 33)

General

The 4140XMPT2 is supplied with a 12.5”W x 14.5”H x 3“D cabinet suitable for

use in residential and non-cedified commercial burglary installations.

Mount the Control cabinet to a sturdy wall using fasteners or anchors (not

supplied) in a clean, dry area which is not readily accessible to the general public.

The back of the Control cabinet has 4 holes for this purpose.

Follow the instructions below for mounting the 4140XMPT2 PC board into the

cabinet and for mounting the Control’s lock to its cabinet door.

Mounting The Before mounting the circuit board, be certain that the appropriate metal

4140XMPT2 PC Board knockouts have been removed. DO NOT ATTEMPT TO REMOVE THE

KNOCKOUTS A~ER THE CIRCUIT BOARD HAS BEEN INSTALLED.

Hang the three mounting clips on the raised cabinet tabs. Observe proper

clip orientation to avoid damage to the clip when mounting screws are

tightened and to avoid problems with insertion and removal of the PC board.

Insert the top of the circuit board into the slots at the top of the cabinet, Make

cefiain that the board rests in the slots as indicated in step 2 detail.

Swina the base of the board into the mountina clim and secure the board to

the ~binet with the accompanying screws (as~llu~rated in step 3 detail).

Advisory

Make certain that the mounting screws are reasonably tight to insure that there is

a good ground connection between the PC board and the cabinet. Also, dress

field wiring away from the microprocessor (center) section of the PC board. The

cabinet provides 2 loops on its left and right sidewalls for anchoring field wiring

using tie wraps. These steps are important to minimizing the risk of panel RF

inte~erence with television reception.-

Slw a

—

f--=%Y// “’cY’

DETAIL SIDE MEW OF

CLIP lNSTALLAnC+(

b. CAOINEl TAB

WITHOUT CLIP

0.CAWNW TAB

wm MN01N13 cL*

DETAIL SIDE VIEW

OF CLIP ANLI BOARD

INSTALLED

Mounting The Cabinet 1.

Lock

Remove the lock knockout on

the control cabinet cover, Insert

the key into the lock. Position the

lock in the hole making certain

that the latch will make contact

with the latch bracket when the

door is closed.

While holding the lock steady,

insert the retainer clip into the

retainer slots.

LOCKED

(,0

RETAINER CUP

‘@

... :

. .

-..

““””\

UNLOCKED

c.AwNEl

OcoFlEa-mM

.m#mcw_

REIuNER

S1.ols

-33-

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO 4140XMPT2 Manual de usuario Pagina 33

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4140XMPT2