ADEMCO 4140XMPT2 Manual de usuario descargar pdf (Pagina 24)

Remote Keyswitch

If the keyswitch option is selected (field ●15), the alarm trigger outputs are

disabled.

An optional Remote Keyswitch can be used for remote arming and disarming of

the system. Note that keyswitch arming may only be used in one ~

E ‘artiti”n”

If used, program field ●15 must be set to the desired partition to enable the

keyswitch option, and the4146 keyswitch’s normally open momentary switch and

LEDs must be connected to Zone 7 and to the J7 connector trigger outputs

respectively. A 2k EOL resistor must be connected across the switch regardless

of whether or not zones 2-8 are selected to use EOL resistors. See diagram

below.

Note that the system automatically assigns zone type 10 to zone 7 if keyswitch is

used.

A momentary short across this zone will arm the system in the “AWAY” mode. If

the short is held for more than 3 seconds, the system will arm in the “STAY”

mode. (i.e. all zones designated as zone types 4 or 10 will be automatically

bypassed). After the system has been armed, the next time zone 7 is shorted,

the system will disarm.

An optional closed-circuit tamper switch (model 112) can be wired in series with

zone 7, so that, if the switchplate is removed from the wall, the tamper wiil open,

disabling keyswitch operation until the system is next disarmed from the console.

Note:

Only one keyswitch with LEDs can be supported by the system’s

power supply.

Note:

Open/close reporting for keyswitch is enabled in field ’40, and the

keyswitch reports as user O.

LED indications are defined as follows:

Green

Red

Meaning

off

Disarmed & Not Ready

off

Disarmed & Ready

off On Steady

Armed Away

off Slow Flash

Armed Stay

off

Rapid Flash Alarm Memory

i f I I

I i 2 3A 567 8 9

—l——r ~--

TO AUX POWER

TERMINAL 6

IF KEYSWITCH IS USEO.

1] OUT 1 CAN STILL BE USED TO PROVIDE

GROuND START, OPENicLOsE {SEE FIELD I. 46}.

2) OUT 2,3,4 NO LONGER PROVIDE ALARM

STATUS lNOICATIONS OUT 2 & 4 OPERATE

KEYsWITCH LEDs OUT 3 IS NOT USED.

ONLY 1 KEYSWITCH CAN BE USEO.

3) ZONE 7 IS NO LONGER USA6LE AS ,4

PROTECTIVE ZONE.

TO ZONE 7

TO TERM. 20

TO TERM 19

BROKEN LINES REPRESENT

INSTALLER WIRING CONNECTIONS

(

“-*’20”1-

.—.——.—-———--—-—

TAMPER

SWITCN IN. C.)

--—. --

63!

--—

LOCK

SWITCH IN 0.)

---- --

++---;

I 1----

2000

OHMS

L------ $

EOLR

-24-

4146 KEYSWITCH

(NOT UL LISTED)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO 4140XMPT2 Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4140XMPT2