ADEMCO 4140XMPT2 Manual de usuario descargar pdf (Pagina 32)

EXTERNAL SOUNDERS

Relay Output

UL Household

Installations

Non-UL Installations

Compatible Sounders

702

Outdoor Siren (not UL

Listed)

719

Compact Outdoor

Siren (not UL Listed)

740

High intensity Sounder

747

indoor Siren

ABB1031

Motor Beii & Box

PA400B

(beige)/PA400R (red)

indoor Piezo Sounder

The Control provides a wet beli relay output which is used to power externai aiarm

sounders. Connections are made to terminais 4 (positive output) and 5 (negative

return). See SUMMARY OF CONNECTIONS Diagram.

For installations which must provide (JL Listed protection, the total wrrent drawn

from this output and the auxiliary power output, combined, must not exceed

750mA in order to wmply with the battery independence requirements. if two

System Sensor PA400 piezo alarm sounders, wired in parallel, are used (24mA

total),then (750MA - 24mA=) 726MA isavailable for auxiliary output use.

For non-UL installations, the total current drawn from this output can be up to 2.8

amps. A battery must be installed since current in excess of 750mA is suppiied by

the battery. Up to two 702 sirens can be used, wired in series. Up to two 719

sirens can be used wired in parailel.

iMPORTANT: Going beyond the above mentioned limits will overload the

power supply or may possibly trip the beli output cirwit protector.

● Self-contained siren (driver built-in) and weatherprmf for outdoor use. Can be

wired for either a steady or yeip sound and is rated at 120 dB @ 10 feet. This

siren can also be tamper protected, or can be mounted in a metal cabinet (716),

which can be tamper protected.

● Compact, self-contained siren (driver buiit-in), and weatherproof for outdoor

use. Can be wired for either a steady or yelp sound, and is rated at 90 dB @ 10

feet. A 708BE cabinet is available, which can be tamper protected if necessary.

● Compact high intensity sounder rated at 123 dB @ 10 feet. This sounder emits

an ‘ear piercing”, high frequency sound. Th”~ sounder can be mounted indoors

(bracket included) or outdoors (in 708BE cabinet).

● Attractive, self-contained indoor siren (driver built-in), provides steady or warble

tones and is rated at 95dB @ 10 feet.

● AMSECO motor bell& box, rated at 81 dB @ 10 feet.

● System Sensor indoor piezo sounder (red or beige), rated at 90 dB @ 10 feet.

UL NOTE: Use only UL Listed sounding devices for UL installations.

PHONE CONNECTIONS

Phone Line incoming phone tine and handset wiring is connected to the main terminai biock

Connections as follows (referto SUMMARY OF CONNECTIONS Diagram):

TB1

-26: Local Handset (TIP)

TB1-27: Local Handset (RING)

TB1-28:

Incoming Phone Line (TIP)

TB1-29: IncomingPhoneLine(RING)

If it is desired to connect the panel to phone lines that require ground statl

capability, then a 675 Ground Start Module must be used. This moduie is

trggered by one of the outputs on the connector Iabeied J7 (see VOLTAGE

TRIGGERS section).

Warning

To prevent the risk of shock, disconnect phone lines at teica jack before servicing

the panel.

PABX

If the communicator is oonnected to a telephone line inside a PABX, be sure the

PABX has a back-up power supply that can support the PABX for 24 hours. Many

PABXS are not power backed up and connection to such a PABX wili result in a

communication failure if power is lost.

-32-

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO 4140XMPT2 Manual de usuario Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4140XMPT2