ADEMCO 4140XMPT2 Manual de usuario descargar pdf (Pagina 18)

-.. –... .. . . . . . . . .. . . .. . .

4280 8erles Receiver

4280 is not recommended

for new installation; receiver

is scheduled to be

discontinued.

4281 8erke Receiver

5881 8eriee Receiver

House ID

Receiver Address

Cover Removal

Go/NoGoMode

Spatial Diversity

Transmitter ID

4280 series

Connects to polling

loop

set via D1Pswitches

Set by cutting blue

lumper in 2nd

receiver. Enabled

via fields 1“26 &

●27.

Causes alarm or

trouble depending

on response type

assigned.

Requires cover

removal.

No. Requires2

receivers for

redundancy or to

expand area of

coverage.

Set via DIP

switches.

4281 series

5881 series

Connects to

console lines

programmed via #93

Menu Mode.

Set via

DIP

switches.Enabled

via#93 Device

Programming.

Does-not cause

alarm or trouble.

Set via DIP

switches. Enabled

via #93 Device

Programming.

Does not cause

alarm or trouble.

Automatic upon

entering test mode.

Yes. Eliminates

nulls and voids. 2nd

receiver expands

coverage area or

provides additional

redundancy.

Set via DIP

switches.

Automatic upon

entering test mode.

Yes. Eliminates

nulls and voids. 2nd

receiver expands

coverage area or

provides additkmal

redundancy.

Serial numbers are

“learned” by the

system.

●

✎

●

✎

●

✎

●

lm~ortant: Note that if usirw two RF Receivers, one of them must be

powered from auxiliary power; so as not to exceed the 64mA polling loop

current rating.

Set field 1*32 to O.

For more information regarding the 4280 installation, refer to the installation

instructions provided with the 4280.

If using a 4280-8, only up to 8 zones can be enabled as RF zones. If more than

8 zones are enabled, the message “SET-UP ERROR” (or E8 on non-alpha

consoles) will be displayed.

Refer to the maximum polling loop wire runs described in the POLLING LOOP

section when connecting 4280s to the polling loop.

IMPORTANT: The maximum combined polling loop run is 4000’. If using

shielded wire, the maximum is 2000.

Set field 1*32 to 1.

Using #93 Menu mode-Device Programming, select as RF device type.

Set house ID via #93 Menu Mode.

Set receiver% device address using its DIP switches. Lower numbered

address is primary receiver (supervisory fault ID 90,

91). Higher numbered

address is secondary receiver (receiver fautt ID 88, 89).

Important: 4281 microprocessor must have part number N5334VX, where x is

any number. The microprocessor is located just above the DIP switch on the

PC board.

Set field 1*32 to 2.

Using #93 Menu mode-Device Programming, select as RF device type.

Set house ID via #93 Menu Mode (needed for 5827 keypad only).

Set receivets device address using its DIP switches. Lower numbered

address is primary receiver (supervisory fault ID 90, 91). Higher numbered

address is secondary receiver (receiver fault ID 88, 89).

-18-

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO 4140XMPT2 Manual de usuario Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4140XMPT2