ADEMCO 4140XMPT2 Manual de usuario descargar pdf (Pagina 11)

ZONE TYPES & APPLICABLE SENSORS

Type 00

Zone Not Used

Type 01

Entry/Exit #1 Burglary.

Type 02

Entry/Exit #2 Burglary.

Type 03

Perimeter Burglary.

Type 04

Interior, Follower.

Type 05

Trouble by Day/Alarm

by Night.

The 4140XMPT2 supports up to 87 zones of hard-wire, polling loop and/or

wireless protection, distributed among up to 8 partitions. The following table lists

the zone numbers and the types of sensors that can be used with each in this

system:

one

Sensors

2-wire smoke detectors (if used)

7 keyswitch (if used)

latching type glass break detectors (if used)

1-9

traditional hard-wired zones

1-63 5700 eeries wirelees devices

1-87 5800 series wireless devices

10-87 polling loop devices

“/1 panic

96 #13panic

●/# panic

Each zone must be assigned to a zone type, which defines the way in which the

system responds to faults in that zone.

In addition, there are three keypad

activated zones (PANIC keys, see note below) for each partition, a polling loop

supervision zone, and four RF supervisory zones, two for each RF Receiver

installed, Zone types are defined below.

Program a zone with this zone type if the zone is not used,

This zone type provides entry delay whenever the zone is faulted if the control is

armed in the Away or Stay modes. When the panel is armed in the Instant or

Maximum modes, no entry delay is provided. Exit delay begins whenever the

control is armed, regardless of the arming mode selected. These delays are

programmable. This zone type is usually assigned to sensors or contacts on

doors through which primary entry and exit will take place.

This zone type provides a secondary entry delay whenever the zone is faulted if

the

panel is armed in the Away and Stay modes. When the panel is armed in the

Instant or Maximum modes, no entry delay is provided. Secondary exit delay

begins whenever the control is armed, regardless of the arming

mode selected.

These delays are programmable. This zone type is usually assigned to sensors or

mntacts on doors through which secondary entry and exit will take place, and

where more time might be needed to get to and from the console. Delay time must

be greater than Zone type 1. (Ex.: a garage, loading dock, or basement door)

This zone type gives an instant alarm if the zone is faulted when the panel is

armed in the Away, Stay, Instant or

Maximum modes. This zone type is usually

assigned to all sensors or contacts on exterior

doors and windows.

This zone type gives a delayed alarm (using the programmed Entry/exit time) if

the Entry/Exit zone is faulted first. Otherwise this zone type gives an instant

alarm. This zone type is active when the panel is armed

in the Away or maximum

modes. Maximum mode eliminates the delay though. This zone type Is

bypassed automatically when the panel Is armed In the Stay or

Instant modes. This zone type is usually assigned to a zone covering an area

such as a foyer, lobby, or hallway through which one must pass upon entry (After

faulting the entry/exit zone to reach the console to disarm the system.) Since this

zone type is designed to provide an instant alarm if the entry/exit zone is not

violated first, it will protect an area in the event an intruder hides on the premises

prior to the system being armed, or gains access to the premises through an

unprotected area.

This zone type will give an instant alarm if faulted when armed in the Away, Stay,

Instant or Maximum (night) modes. During the disarmed state (day), the system

will provide a latched trouble sounding from the console (and a central station

report, if desired). This zone type is usually assigned to a zone which contains a

foil-protected door or window (such as in a store), or to a zone covering a

“sensitive” area such as a stock room, drug supply room, etc. This zone type can

also be used on a sensor or contact in an area where immediate notification of an

entry is desired.

-11-

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO 4140XMPT2 Manual de usuario Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4140XMPT2