ADEMCO VISTA-250FBP Guia de preparacion descargar pdf (Pagina 58)

— 58 —

Output Devices Worksheets

Applicable only if relays (4204/4204CF) or V-Plex are used.

Output Devices – Programmed in the #93 Menu Mode in the Output Programming Section. Fill in the required data on

the worksheet below and follow the procedure in the installation instructions as you enter the data during the displays

and prompts that appear in sequence.

NOTES:

1. For 4204/4204CF, the Device Programming section must be programmed for the device address. Set the

DIP switches on the device for that address.

2. For V-Plex, devices must be programmed in the Zone Programming section

3. If you are using outputs on V-Plex (e.g., 4101SN) no more than 20 of the V-Plex outputs may be

programmed for the same START or STOP condition. Also, if you are using ZONE # for the START of a

V-Plex output and want that output to stop when the same zone restores, the STOP programming MUST

BE BLANK.

START

STOP

OUTPUT

DEV #

EV/ZL Zone ZT / P ZL ZT / P

Relay

Group

Restrict

0=V-Plex

1=4204/

4204CF

V-Plex Zone #

Dev Add

4204/4204CF

Relay # for

4204/

4204CF

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 71 72

Sin comentarios

ADEMCO VISTA-250FBP Guia de preparacion Pagina 58