ADEMCO VISTA-250FBP Guia de preparacion descargar pdf (Pagina 34)

– 34 –

The 6160/6160CR-2 Keypad displays the following prompts, which are sent by the Communicator to the control. NOTE:

These prompts are for the 7845i-ent Communicator only. If you are using a different communicator, refer to the

communicator’s instructions for the correct prompts.

PROMPT

EXPLANATION

DEVICE ADDRESS

Enter the device address of the Communicator. The default address is 3.

ID #

(1234)

Enter the 4-digit customer account number, 0001-9999. This ID number will appear in the messages

generated by the Communicator. Messages generated by the panel and transmitted by the Communicator

will contain the ID number programmed into the panel. The Communicator and the panel should have the

same ID number, if possible.

If a different 4-digit customer account number is used in the Communicator that is programmed into the alarm

control, the Communicator will transmit Communicator-specific messages (power-on reset, AC fail, etc.) using the

Communicator customer number, and alarm messages using the control panel’s customer number. If these

numbers are different, you will be billed for two AlarmNet Communicator accounts.

PROMPT

EXPLANATION

ODD [Y/N]

(N)

Enter Y for odd system flag; N for even system flag.

Alarmnet (Y/N)

(Y)

Enter Y if this is an AlarmNet installation. Enter N if this is a private system and skip to Question 7.

CS ID

(11)

Enter the primary central station’s system ID number 1-7F (will not be displayed for private system users).

BAT PRESENT [Y/N]

(N)

Enter Y if optional battery will be used. Must be Y for UL installations (a battery must be installed).

USE RADIO # [Y/N]

(N)

If you selected Y, the Communicator ID number replaces the panel Subscriber ID in panel-generated

messages.

If you selected N, the Communicator sends panel-generated messages with the panel Subscriber ID

number.

CS ID

(12)

This must be programmed with a value, even if it is the same as the primary central station. The

alarm panel has the option of sending a selected message to the second central station.

REVIEW (Y/N)

(N)

Enter Y to review the programming options and to ensure that the correct responses have been made.

Parameters can be changed during review.

Enter N to end programming session.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 71 72

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-250FBP Guia de preparacion Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-250FBP