ADEMCO VISTA-250FBP Guia de preparacion descargar pdf (Pagina 5)

–5–

NOTE: All references in this manual for number of zones, number of user codes, number of access cards, and the

event log capacity, use the VISTA-250FBP’s features. The following table lists the differences between the VISTA-

128FBP and the VISTA-250FBP control panels. All other features are identical.

Feature VISTA-128FBP VISTA-250FBP

Number of Zones 128 250

Number of User Codes 150 250

Event Log Capacity 512 1000

The purpose of this document is to provide a quick and easy way to program your entire system. A recommended

programming procedure is included, followed by a list of program fields with the corresponding program group they belong to

(system-wide, partition-specific, scheduling, etc.). Two program forms are included. One contains all the programming fields,

and the other contains the partition-specific fields. If you are setting up a single-partition system, the partition-specific fields

become system-wide fields.

Following the program forms are system layout worksheets. We recommend that you use these sheets to plan your system

before programming is performed. If you need further information about specific programming options, see the

VISTA-

128FBP/VISTA-250FBP Installation and Setup Guide

Make sure that one two-line alpha keypad is connected to the control and is set to device address "00."

Single-Partition System

The system default is for a single-partition system. Use the VISTA-128FBP/VISTA-250FBP SINGLE PARTITION

PROGRAMMING FORM when programming for single-partition usage. Follow the steps outlined in RECOMMENDED

PROGRAMMING PROCEDURE of this document for proper programming procedure.

Multiple-Partition System

You must enter the number of partitions you are using in data field 2*00 to set the system for multiple partitions. Use the

VISTA-128FBP/VISTA-250FBP SINGLE PARTITION and the PARTITION-SPECIFIC PROGRAM FORMS when

programming the system for multiple partitions. Follow the steps outlined in RECOMMENDED PROGRAMMING

PROCEDURE of this document for proper programming procedure.

SUMMARY OF PROGRAMMING COMMANDS

• To enter program mode, enter installer code + [8] + [0] + [0] + [0]

• To set standard defaults, press ✱97

• To change to next page of program fields, press ✱94

• To return to previous set of fields, press ✱99

• To erase account and phone number field entries, press [✱] + field number + [✱]

• To assign zone descriptors, press #93 + follow menu prompts

• To add custom words, press #93 + follow menu prompts

• To enter Installer's Message, press #93 + follow menu prompts

• To exit program mode, enter ✱99 OR ✱98: ✱99 allows re-access to programming mode by installer code.

✱98 prevents re-access to programming mode by installer code. The only way to re-access programming

mode is by depressing both the [✱] and [#] keys at the same time within 30 seconds of power-up.

Standard default (✱97) values are shown in brackets [ ], otherwise default = 0.

1 2 3 4 5 6 7 8 9 10 ... 71 72

Sin comentarios

ADEMCO VISTA-250FBP Guia de preparacion Pagina 5