ADEMCO Security System VISTA-15 Especificaciones descargar pdf (Pagina 69)

SECTION 12

System Operation

•••••••••••••••••••••••••••••••••••••••

Security Codes

The VISTA-20P system supports up to 48 security codes (VISTA-15P supports 32 codes), which can

each be assigned one of 5 authority levels. The authority level determines the functions each code

can perform as follows:

Authority Levels

(authority levels can be assigned to users 3-49 only; users 1 and 2 cannot be changed)

Level User No. Functions

Installer 01 perform all security functions except can disarm only if used to arm;

can enter program mode (default=4112)

System 02 only one system master code per system; can perform all security

Master functions, add/delete users in either partition, change master code, view

event log, set system clock, program keypad macro, program scheduled

events, activate output devices (triggers/relays)

Partition P1 = 03 VISTA-20P. Same as Master, except add/delete users limited to

Master P2 = 33 assigned partition only, (these users can be assigned different authority

(default) levels, if desired; any user can be assigned the partition master authority

level)

0-User

03-49

(V20P

)

perform security functions (arm, disarm, etc.) only; cannot add/delete

03-33

(V15P)

users, view event log, set system clock or program scheduled events

1-Arm Only see “user” arm system only

2-Guest see “user” can disarm the system only if it was used to arm the system

3-Duress see “user” performs security functions, but also silently sends a duress message to

the central station; reports as duress code user number.

4-Partition see “user” VISTA-20P. See Partition Master paragraph above; used to assign

Master other user numbers as partition masters

Refer to the user guide for detailed procedures on adding/deleting security codes and changing user

attributes.

The following is a brief description of how to add user codes.

Adding a User Code: Master code + [8] + 2-digit user no. + user’s code

Deleting a User Code: Master code + [8] + 2-digit user no. + [#] [0]

Assigning Attributes: Master code + [8] + 2-digit user no. + [#] [attribute no.] + value

Attributes: Values

1 = Authority Level 0-4 (see Authority Level table above)

2 = Access Group 0-8 (0 = not assigned to a group)

3 = Active Partition(s) 1, 2, 3 (common)

for this user; Enter partitions consecutively if more than one

and press [#] to end the entries.

4 = RF Zone No. Assigns user number to button type zone for

arm/disarm.

5 = Open/Close Paging 1 for yes, 0 for no

12-1

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 87 88

Comentarios a estos manuales

Sin comentarios

ADEMCO Security System VISTA-15 Especificaciones Pagina 69

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Security System VISTA-15