ADEMCO Security System VISTA-15 Especificaciones descargar pdf (Pagina 41)

SECTION 5

Zone Programming

(

✱

56 and

✱

58 Menu Modes)

••••••••••••••••••••••••••••••••••••••••••••••••••

About Zone Programming

✱

56 Zone Programming is used to program zones, zone types, report codes, enroll 5800 RF Wireless

Transmitter serial numbers, and identify the type of loop input device(s). This mode can also be used

to enter alpha descriptors for programmed zones; however, we recommend entering descriptors in

menu mode

✱

82 (

Alpha Descriptor Programming

after all zone programming has been completed).

For a faster method of zone programming, you can use the

✱

58 Expert Programming Mode instead of

✱

56 Zone programming. The

✱

58 Expert Programming Mode is designed for those who have had

previous experience in programming control panels of this type.

NOTE: Alpha display prompts are shown in a double-line box.

✱

56 Zone Programming Procedure

Zone Programming involves:

1. Entering the zone number to be programmed;

2. Making appropriate entries at the prompts;

3. Confirming the serial number of wireless transmitter zones.

Start Zone Programming mode by pressing

✱

56 while in Data Programming mode. The following

prompts are displayed:

PROMPT VALID ENTRIES EXPLANATION

SET

TO CONFIRM?

0 = NO 1 = YES

Set to Confirm

0 = no

1 = yes

If 1 (Yes) is entered, you will be prompted to confirm each

transmitter after entering the serial and loop numbers (at the “XMIT

TO CONFIRM” prompt later in this procedure).

We recommend

that you confirm the programming of every transmitter.

Enter Zn Num.

(00 = Quit) 10

Zone Number

VISTA-20P:

wired zones 01-08

wireless zones 09-48

button zones 49-64

VISTA-15P:

wired zones 01-06

wireless zones 09-34

button zones 49-56

Both Controls:

91 = addr. device report enable

92 = duress report enable

95, 96, 99 =emergency zones

00 to quit

[

∗

] to continue

Enter the zone number that you wish to program. Zone 10 has been

entered as an example in the display at left.

Enter a report code for zone 91 to enable addressable device

reporting.

Enter a report code for zone 92 to enable duress reporting.

95, 96, 99 are emergency (panic) key zones.

Zn ZT P RC In: L

10 00 1 10 RF: 1

Zn ZT P RC In: AD

10 00 1 10 AW: 07

Zn ZT P RC HW: RT

10 00 1 10 EL 1

Summary Screen

[

∗

] to continue

A summary display appears.

“IN: L” appears for wireless zones and indicates input type and loop.

“IN: AD” appears for hardwire expansion zones (AW) and indicates

the module’s address (AD), which is based on the zone number.

“HW: RT” appears for hardwire zones and indicates configuration

(EOL, NO, NC, zone doubling, double-balanced) and response time

selection.

5-1

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 87 88

Comentarios a estos manuales

Sin comentarios

ADEMCO Security System VISTA-15 Especificaciones Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Security System VISTA-15