ADEMCO Security System VISTA-15 Especificaciones descargar pdf (Pagina 45)

PROMPT VALID ENTRIES EXPLANATION

10 INPUT S/N: L

AXXX-XXX –

Serial number

S/N = serial number

L = loop number

[

∗

] to continue

Manually enter the serial number (found on the transmitter label),

by typing digits in the “X” locations, using the [A] (advance) or [B]

(back) keys as required. You can also perform two open and close

sequences; for button-type transmitters that means pressing and

releasing the button twice.

NOTE

If you want to copy the previous zone’s serial number, press

the [C] key.

Press [

✱

] to advance to the loop number, then enter loop number.

Press [

✱

] to accept the existing serial and loop number and continue

to the “Confirm” prompt below. If necessary, press [#] to back up and

re-enter or edit the serial number.

10 INPUT S/N:

A000-0000 0

To Delete a Serial

Number

[

∗

] to continue

To delete an existing serial number, enter

in the loop number

field. The serial number will change to all 0's as shown.

was entered in error, simply re-enter the loop number, and the

serial number will return to the display.

10 XMIT TO CONFIRM

PRESS

✱

TO SKIP

Confirm

[

∗

] to continue

The prompt to confirm appears

This prompt will only appear if the

first prompt after entering ✱58 was answered “Yes.” To confirm,

activate the loop input or button that corresponds to this zone.

The system checks for duplicate. If a duplicate exists, a long error

beep will sound.

Press [#] to back up and re-enter the serial and/or loop number.

Entd A022-4063

Rcvd A022-4064

If Serial or Loop

Numbers do not match

after activating the

transmitter

[

∗

] to continue

f the serial/loop number combination transmitted does not match

the serial and loop number entered, a display similar to the one

below will appear.

If the loop number does not match, it will

also be displayed.

If so, activate the transmitter’s loop input or

button one or more times.

If a match is still not obtained (i.e., summary display does not

appear), press the [#] key twice and enter the correct loop input or, if

correct, press [#] again and then enter the correct serial number.

Zn ZT P RC In L

10 03 1 10 RF:

Note that an “s”

indicates that a

transmitter’s serial

number has been

enrolled.

Summary Screen

[

∗

] to continue

If the serial number transmitted matches the serial number entered,

the keypad will beep 3 times and a summary display will appear,

showing the programmed information for that zone.

Press [

✱

] to begin programming the next zone. See first “Summary

Screen” prompt paragraph on previous page.

5-5

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 87 88

Comentarios a estos manuales

Sin comentarios

ADEMCO Security System VISTA-15 Especificaciones Pagina 45

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Security System VISTA-15