ADEMCO Accord Manual de instalación descargar pdf (Pagina 64)

Night Set 3 ( )

To Night Set the system:

• Enter your User Code then press the 3 (Night Set) key.

• This starts the setting of the system using the Night Set zone programming.

This allows a sub-set of the system to be set.

• The Day LED (•) will flash during the Exit Time.

• To cancel the setting procedure press the Ö key.

• When the system sets, two confirmation beeps are emitted by the keypad and

internal speaker; after this the Ö key does not function.

Note: The activation of the keypad buzzer and internal speaker are dependant on the

programming of Group 4 — Option 4 Part Set Exit Warning.

Easy Set allows users to Night Set the system without entering a User Code. If Easy

Set is programmed you may set the system by pressing the # key, then the 3 (Night

Set) key. See SECTION 3: Programming the Accord; Group 4 – Option 8 Easy Set.

Unsetting [4]

To Unset the system the user should go to the keypad via the agreed entry route and

enter their user code.

Unsetting After or During an Alarm

On the keypad the LED or zone number corresponding to the first zone to go into

alarm illuminates. Entering a User Code stops any alarm that is in progress. To reset

the system enter the User Code again. If set for engineer reset after an alarm, entering

the Engineer Code causes an Engineer Reset. If the system is set for a technistore reset

after an alarm, all LEDs will illuminate for 1.5 seconds or the CE message will appear

followed by the zone number (Icon Keypad). All keypads will then display the 5 digit

technistore code, one digit at a time (each digit corresponds to an illuminated LED on

the LED keypad). Enter this code at the monitoring station to obtain an anticode which

when entered causes Technistore reset is overridden if there is a comms fail.

Note: The user code cannot reset the system after an alarm condition if Group 5 –

Option 3 (Engineer Reset for Alarms) has been programmed for Engineer

Reset or Technistore Reset.

Engineer Setting and Unsetting

The Engineer Code can be used to set the system (Full, Part or Night). It can only be

used to unset the system when it was previously used to set it.

Testing the System 5 (

)

To Test the zones and outputs on the system enter a valid code then press the 5 ( )

key.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 77 78

Sin comentarios

ADEMCO Accord Manual de instalación Pagina 64