ADEMCO Accord Manual de instalación descargar pdf (Pagina 45)

2. Push-to-Set on Full Set and Part Set.

3. Push-to-Set on Full Set and Night Set.

4. Push-to-Set on all set modes.

This option defaults to disabled 0 (Push-to-Set not used).

Note: Push-to-Set on Full Set is over-ridden when Final Contact is programmed

(Group 4 Option 1 = 0).

Group 7 — Option 6 When to Communicate

This option determines under which set conditions the panel communicates following,

Alarm, Abort, Verified Alarm and Tamper. This option has four modes of operation:

0. Full Set only.

1. Full Set and Part Set.

2. Full Set and Night Set.

3. All Sets (Full, Part and Night).

This option does not affect any other signals. Communication of Set/Unset is only

sent for Full Set conditions.

This option defaults to 3 (All Sets).

Group 7 — Option 7 Line Fail

If this option is disabled (set to 0) there is no internal alarm or indication in the event

of a line fail condition being detected.

If this option is enabled (set to 1), a line fail condition will cause an internal alarm. An

audible indication is accompanied by the illumination of the Telephone LED ( ) on

the keypad. A Line Fail indication does not activate until 40 seconds after detection of

the line fail.

The audible indication of the line fail is cancelled by the entry of a valid user code but

the Line Fail LED ( ) remains illuminated until 30 seconds after the Line Fail

condition is restored.

The communicator still attempts to dial out in the event of an alarm, even if a Line

Fail condition has been detected. When the panel cannot dial due to the Line Fail

condition the Comm Fail indication (flashing telephone LED ( )) does not override

the Line Fail indication (telephone LED ( ) on steady).

This option defaults to 1 (enabled).

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 77 78

Sin comentarios

ADEMCO Accord Manual de instalación Pagina 45