
9
Fitting the Tamper Switch
The Accord xpC enclosure is supplied without a Tamper Actuator in place. The panel
will not function without a Tamper, it is therefore, the installer’s responsibility to
correctly attach the Tamper Actuator. The Tamper Actuator consists of a spring,
which is supplied in the Accord xpC Installation Kit, and one of the Knockout Tamper
Posts, see figure 2.1. The installer should knockout one of these Tamper Posts from
the enclosure base and ensure the spring is securely attached to the short end of the
Tamper Post, before fitting the opposite end of the spring to the Tamper Switch (SW1)
on the PCB (see below).
_
Comentarios a estos manuales