ADEMCO 5130XM Manual de instrucciones descargar pdf (Pagina 9)

— 2-WIRE POLLING

(Zones 10

GENERAL INFORMATION

To expand the system using a 2-wire polling loop

and remote point modules (RPMs), a 4171XT-XM

dialer board, and a 4152LMB loop module must tM

installed,as describedin the ZONE EXPANSION

MODULE section.

Wire each of the RPMs in parallel to the 2-wire

polling loop, making sure no more than the

maximum allowable wire length is used per

individual polling loop run, as follows:

#22 gauge @ 650’ max

#20 gauge @95Cr’max

#18 gauge @l 500’ max

#18 gauge @2400’ max

NOTE: Twisted pair recommended for ail normal

wire runs.

IMPORTANT:

The maximum combined polling

loop run is 4000’. If using shielded wire, the

maximum is 2000’. If longer wire runs are needed,

a 4197 Loop Extender Module must be used.

LOOP EXPANSION —

through 64)

CAUTION

If an intercom system is being used, the polling loop

wires must be as far from the intercom wiring as

possible (minimum 6-). If this spacing cannot be

achieved, shielded wire must be used. If this is not

done, interference on the intercom system might

occur. Also note that the maximum total wire

length supported is cut in half when shielded wire is

used.

ADVISORY

The maximum allowabte current draw on the polling

loop is 64mA. Refer to the Polling Loop Current

Draw Worksheet (found in the POWERING THE

SYSTEM section of this manual) for current draws

of various polling loop devices. If more than 64mA

is bdng drawn, use of the 4197 provides another

loop with 64mA available. Refer to the instructions

provided with the 4197, or the Technical Reference

Manual for complete information.

— WIRELESS EXPANSION—

The VISTA XM system supports up to 63 Alert Ill

IMPORTANT: All RF zones must be designated as

Transmitters, plus a wireless keypad. To expand

such in their respective program fields. If using a

the system using wireless, one or two 4280 RF

4280-8, only up to 8 zones can be enabfed as RF

Receivers (or 4280-8 if only 8 wireless zones are

zones. If more than 8 zones are enabled, the

used) must be connected to the polling loop. The

message “SET-UP ERROR” (5130XM/51 37) or “E~

4280 can receive signals from wireless

(41 30 XM/41 37) will be displayed. For more

transmitters within a nominal range of 200 feet. In

information regarding the 4260 installation, refer

addition, two 4280s can be used to provide either a

to the Installation Instructions provided with the

greater area of coverage, or to provide redundant

4280.

WIRELESS

protection. Note that if using 2 RF Receivers; one

PERIPHERALS

of them must be powered from Auxifiary power.

SMOKE

~DEW@

4220

DOOR

42S0-6

RECEIVER

VISTA

CONTROL

415P

LMeo

RPMDEVICES

POLLING LOOP

RPM

BASIC9 HARD-WIREDZONES

COMBINATIONCONFIGURATION

USINGMARDWIRE,2-WIREPOLLINGLOOP

ANDWIRELESSTECHNOLOGIES

-7-

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Comentarios a estos manuales

Sin comentarios

ADEMCO 5130XM Manual de instrucciones Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 5130XM