ADEMCO 5130XM Manual de instrucciones descargar pdf (Pagina 11)

— PASSIVE INFRARED MOTION DETECTORS —

GENERAL INFORMATION

POLLING LOOP PIR (4196)

Select a mounting site with the following notes in

The 4196 is a quad element passive infrared

mind: Best coverage will be obtained if the

detector with a built-in RPM that is connected

mounting site is selected such that the likely

directly to the 2-wire polling loop.

direction of intruder motion is across the pattern of

POLLING LOOP PIR (4275)

protection.

The 4275 is a dual element passive infrared

● Avoid locating the unit where central heating

detector, with a built-in RPM, that is connected

radiators, flames or heating outlet ducts are

directly to the 2-wire polling loop.

within the protective zones.

WIRELESS PIR (5775)

● Avoid locating the unit in direct sunlight or

The 5775 is a battery operated, wireless, dual

directly above strong sources of heat.

element passive infrared motion detector that can

● Avoid locating the unit on unstable surfaces.

be monitored by a 4280 (4280-8) wireless

● Avoid running alarm wiring close to heavy duty

receiver. The 4280 is connected to the 2-wire

electrical cables.

polfingloop.

—

PHONE LINE INTERFACE —

4171 XT-XM/4171XM INSTALLATION 4171 XT-XM/4171XM TERMINALS

The 4171 XT.XM is factory installed in the 4140XM Term. 1: Programmable output (see 1

●46) that can

Control.

For the 4130XM/51 30XM Controls,

be used as a ground start output with the 675

connect the 4171 ~-XM or 4171 XM as shown:

Ground Start Module (not UL Listed), as an outputto

produce console audible warnings on a remote

sounder (ex: No. 706-12), or as an open/close

trigger for use with other communicationsmedia.

ST-S u,

Q Only one of the above optionscan be chosen.

—

un9*8-

-- m-)

mac4muac,

HUIDaas

If either GROUND START, or CONSOLE AUDIBLE is

w_—s

—

●

used, Aux. Voltage Trigger pin 4 may not be used.

Term. 2: INCOMING PHONE UNE (TfP)

●

~,,~e,.,,~ Term.3: INCOMINGPHONE UNE (RING)

*TC-ACE

ammo

Term. 4: LOCAL HANDSETS (RING)

Term. 5: LOCAL HANDSETS (TIP)

● c—

;::;? ~&#”

-c -S*

GROUND: Connect green flying lead to a proper

—nal —nm

N?ww yml?a-

earth ground.

*- -Au

moon o-tn

~=mmmoem

WARNING:

To prevent the risk of shock,

disconnect phone lines at telco jack before

servicing the unit.

—

EXTERNAL SOUNDERS —

4140XM

4148 RELAY MODULE (2.8 AMPS @28 VDC)

The 4140XM is housed in a metal cabinet and

Other sounders (ex. 702 and 719 self-contained

contains a built-in relay, rated at 2.8 amps. The

sirens) can be used with the 4130XM/5130XM, but

output of this relay is a positive (+) trigger from

the addilion of the 4148 Relay Module is necessary

terminal 8 on TB2, with the negative from TB2-15.

because these sirens (or equivalent) draw more

Up to two 702s can be used wired in series; up to

than the allowable 100mA of current.

two 719s in parallel.

ADVISORY:

4130x M/5130x M

Going beyond the above mentioned limits will

The 4130XM/51 30XM self-contained Controls have

overload the auxiliary power and/or relay fuse.

an external sounder output of 100mA, (negative-

Note that the 5130XM and 4130XM use built-in

going (-) trigger) from the brown lead. The

eolid state fuses (PTCS) that do not need replacing.

continuous. positive (+) is taken from the red/black

The 4140XM

uses standard fuses (located on the

lead. From this output you could use up to two 740

terminal strip) which must be replaced if blown.

High Intensity Sounders, wired in parallel, or one

Arnseco Motor Bell, ABB1031, or

Piezo Sounders, BRK PA400B in

up to eight indoor

parallel.

-9-

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comentarios a estos manuales

Sin comentarios

ADEMCO 5130XM Manual de instrucciones Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 5130XM