ADEMCO 5130XM Manual de instrucciones descargar pdf (Pagina 12)

IV. MOUNTING AND POWERING THE SYSTEM

Note that field wiring to these controls/consoles must be completed before the controls/consoles can be

,-:xmted.

.!RFACE MOUNTING

Use the template provided (on a separate

sheet) to mark the positions on the wall for the

screw mounting holes and the cut-out for the

wiring.

2. Pull the interface wiring in the wall through the

cut-out.

3. Remove the console’s back cover. The securing

screw at the front of the console must be removed

to release the back cover .

4. Pass the interface wiring through the opening

in the back cover and through the 4143 Expansion

Ring (if used), then mount the back cover to the

wall surface with screws.

Splice the interface wiring to the console wires

(or to the wires on the interface connector supplied

with 4137s). Insulated solderless wire splices (eg.

311 ) may be used for splicing.

6. Attach the main body of the console to the

wall-mounted back cover. The console is properly

attached when it snaps into place. Use the securing

screw (previously removed) to secure the console

to the back cover .

1 1.1/2-MIN(4 cm)

WALL

‘b’J\

8“(20.2an)

‘1

4-W4-(12Cml

4 I]

II II

●

FLUSH MOUNTING WITH TRIM RING

Cut out a 4.3/4” high by 8“ wide opening in the

wail between studs, no less than 1-1/2” from

either stud. Use the template provided to mark the

cut-out.

2. insert the fow 1-1/2” long #6 screws through

the mounting hoiss in the supplied Trim Ring and

then attach the four rnstai securing ciips, as shown

in the diagram. Use oniy two or three turns of each

screw, ailowing the metai ciips to hang freely. The

ciips must not protrude beyond the sides of the

Trim Ring or you wili not be abie to instsii the Trim

Ring into the cut-out in the next stsp.

3. instail the trim ring into the cpening in the wall

with the hinge clasps to the right. Making sure the

trim ring is straight, tighten each ciip screw,

makhrg sure that the attached clip siides down into

its guide track.

Instail the Consoie as foilows: Engage the hinge

cisspa on the trim ring with the notches iocated in

the back (right-hand side) of the Console’s front

panei. Swing the left side of the panei toward the

trim ring (the panel wiii pivot on the hinge ciasps),

and press firmly untii the panei “snaps- ciosed.

5. Use the panei securing screw (supplied with the

Console) to secure the left side of the panei.

MErAL

SsCuRINc

CLW

FOR CLARITY,

ONLY ONE

CLIP~

INwus

lLLus’TRmw

* RING

WsmLLEOINWALLJ

-1o-

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Comentarios a estos manuales

Sin comentarios

ADEMCO 5130XM Manual de instrucciones Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 5130XM