ADEMCO Vista-128B PLUS Guia de preparacion descargar pdf (Pagina 32)

– 32 –

Device Programming

This menu is used to program keypads, receivers, and relay modules, etc.

Device Address 00 is always set as an alpha keypad assigned to Partition 1 with no sounder suppression

options, and these settings cannot be changed.

From Data Field Programming mode, press #93 to display "ZONE PROG?" Press [0] repeatedly to display "DEVICE PROG?"

PROMPT

EXPLANATION

DEVICE PROG?

1=YES 0=NO 0

Press [1] to enter

Device Programming

DEVICE ADDRESS

01-30, 00=QUIT 01

The device address identifies the device to the control. Enter the 2-digit device address number to match

the device's physical address setting (01-30).

Notes:

• Device Address 01 is defaulted for an AUI (Symphony) with Keypad Global arm/disarm disabled.

• Device Address 04 must be used for the 4285/4286 Voice Module, if one is utilized. If not, it can be

used for another device type.

• Device Address 24 must be used for TeleSmart, if one is utilized. If not, it can be used for another

device type. If using TeleSmart, you must program Device Address 23 as an alpha console. Do not

connect an actual keypad set to address 23 to the control panel. This setup is necessary for

remote access of TeleSmart.

Press [✱] to accept entry.

Select the type of addressable device as follows:

00 = device not used 06 = long range radio

01 = alpha keypad (6139/6160, AUI) 08 = fire display (FSA)

03 = RF receiver (5881) 09 = Vista Gateway Module (VGM)

04 = output relay module (4204) 10 = panel link module

05 = voice (VIP) Module (4285/4286) 11 = Telesmart

DEVICE TYPE

Press [✱] to accept entry.

Alpha Keypad

PROMPT

EXPLANATION

01 CONSOLE PART.

If you selected device type 01 (alpha keypad), this prompt appears. Enter the addressable device's default

partition number (01 to maximum number of partitions programmed for system in field 2*00). This is the

primary partition for the device. Enter 9 to make this keypad a "Master" keypad for the system.

Press [✱] to accept entry.

01 SOUND OPTION

If you entered device type 01 (alpha keypad), this prompt appears. Keypads can be individually

programmed to suppress arm/disarm beeps, entry/exit beeps and chime mode beeps. This helps prevent

unwanted sounds from disturbing users in other areas of the premises.

Enter a number 00-03 for the keypad sounding suppression options desired for the keypad as follows:

00 = no suppression

01 = suppress arm/disarm & entry/exit beeps

02 = suppress chime mode beeps only

03 = suppress arm/disarm, entry/exit and chime mode beeps

Press [✱] to accept entry.

01 KEYPAD GLBL?

If you entered device type 01 (alpha keypad), this prompt appears. Each keypad can give users with access

to multiple partitions the ability to arm and disarm those partitions from it. To enable this keypad for global

arming/disarming, enter 1. To prevent the ability to use this keypad for global arming/disarming, enter 0.

Press [✱] to accept entry.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 71 72

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista-128B PLUS Guia de preparacion Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista-128B PLUS