ADEMCO Vista-128B PLUS Guia de preparacion descargar pdf (Pagina 24)

– 24 –

Report Code Programming

All report codes are entered using

#93 Menu Mode Programming

, either through

Report Code Programming

, or through

Zone

Programming

while entering other zone information. In the VISTA-128BP/VISTA-250BP, reports are divided into six

categories. These categories represent the main menu options in

Report Code Programming

. Reports and the categories in

which they are found are as follows:

ALARM CODES RESTR, SUPV. CODES

(for groups of 16 zones)

SYSTEM GROUP #1

Zone Alarm Reports Alarm Restore

Trouble

Trouble Restore

Bypass

Bypass Restore

Closing (arm AWAY)

Opening (disarm)

System Low Battery

Low Battery Restore

AC Loss

AC Restore

Periodic Test

Power

Cancel

Program Tamper

SYSTEM GROUP #2 SYSTEM GROUP #3 SYSTEM GROUP #4

Arm STAY

Time Set, Log Reset

Log 50%, 90% Full

Event Log Overflow

Exit Error by Zone

Exit Error by User

Recent Close

Early Open

Early Close

Late Open

Late Close

Failed to Open

Failed to Close

Auto-Arm Failed

Schedule Change

Walk-Test Start

Walk-Test End

The programming sequence that follows assumes that you will be entering all reports for the system at one time. In actuality,

you may skip from one main menu option to another by pressing 0 (N) at each main menu option. To enter report codes, do

the following:

Enter Program Mode: [Installer Code] + 8 0 0 0. Then press #93. Enter 0 (N) at each main menu option until the

Report

Code Programming

option is displayed.

PROMPT

EXPLANATION

REPORT CODE PROG

1 = YES 0 = NO 0

Press 1 (Y) to enter to

Report Code Programming

Zone Alarm Reports

PROMPT

EXPLANATION

ALARM, ID DIGIT?

1 = YES 0 = NO 0

Press [1] (Y) to enter Alarm Report Codes for zones. Press [0] (N) to skip to the next main menu option.

ENTER ZONE NO.

000 = QUIT 001

Enter the zone number for which you are entering the report code.

Press [✱] to continue.

001 REPORT CODE

1st 00 2nd 00 00

Enter the first digit of the Alarm report code (double-digit entry) and press [✱]. Enter the 2nd digit of the

Alarm Report code.

Press [✱] to continue.

ENTER ZONE NO.

000 = QUIT 001

Enter the zone number for which you are entering the report code. When all zone Alarm Codes have been

programmed, enter 000 to Quit.

Press [✱] to continue.

QUIT REPORT MENU

1 = YES 0 = NO 0

If you have completely finished entering report codes, press [1] (Y) to quit

Report Code Programming

. If you

wish to enter other system report codes, enter 0 (N).

Press [✱] to continue.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 71 72

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista-128B PLUS Guia de preparacion Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista-128B PLUS