ADEMCO Vista-128B PLUS Guia de preparacion descargar pdf (Pagina 27)

– 27 –

PROMPT

EXPLANATION

Enter the rest of the codes in the same manner. Other codes in System Group #3 are:

• Early Close

• Late Open

• Late Close

• Failed to Open

• Failed to Close

• Auto-Arm Failed

• Schedule Change

Once you have entered these report codes, the system prompts you with the Quit menu.

QUIT REPORT MENU

1 = YES 0 = NO 0

If you have completely finished entering report codes, press [1] (Y) to quit

Report Code Programming

. If you

wish to enter other system report codes, enter 0 (N)

Press [✱] to continue.

System Group #4 Codes

PROMPT

EXPLANATION

SYSTEM GROUP #4 ?

1 = YES 0 = NO 0

To enter System Group #4 codes, press [1] (YES).

WALK TEST START

1st 00 2nd 00

Enter the first digit of the Walk Test Start Report Code. Press [✱]. Enter the second digit of the report code.

Press [✱] to continue.

Enter the rest of the codes in the same manner. Other codes in System Group #4 are:

• Walk-Test End.

Once you have entered these report codes, the system prompts you with the Quit menu.

QUIT MENU MODE?

1 = YES 0 = NO 0

Enter 1 to exit back to normal Programming mode. Enter 0 to stay in Menu mode.

Alpha Descriptors Programming

You can program a user-friendly English language description/location for all protection zones, relays, keypad panics, polling

loop short, and RF receiver supervision troubles.

Each description can be composed of a combination of words (up to 3) that are selected from a vocabulary of 244 words

stored in memory, and any word can have an "s" or " 's " added to it.

NOTE: Due to the use of 3-digit zone numbers, the first word of the descriptor is limited to 6 characters if you want it to fit on

the top line of the display.

In addition, up to 60 installer-defined words can be added to those already in memory. Thus, when an alarm or trouble occurs

in a zone, an appropriate description for the location of that zone will be displayed at the keypad.

A custom installer's message can be programmed for each partition which is displayed when the system is "Ready" (e.g., THE

PETERSONS’).

1. To program alpha descriptors, enter Programming mode, then press #93 to display "ZONE PROG?"

2. Press [0] (NO) twice to display "ALPHA PROG?".

3. Press [1] to enter

Alpha Programming

There are 6 submenu selections that will be displayed one at a time.

Press [1] to select the mode desired.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 71 72

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista-128B PLUS Guia de preparacion Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista-128B PLUS