
Contact ID This the only format that can identify all 64 protection zones by their unique zone
Reporting
(Contact) ID numbers, and provides a l-digit event qualifier and 3-digit,
specifically defined event code which quickly identifies the condition being
repoited.
Contact ID reports in DTMF (Dual Tone Multi-Frequency @ 10 characters per
second) and responds to a 1400 Hz followed by 2300 Hz handshake, and a 1400
Hz kissoff. This format also uses checksum instead of two message verification.
A complete report takes under 3 seconds.
Contact ID Reporting takes the format: CCCC Q EEE GG ZZZ where:
Cccc =
Q=
EEE =
GG =
Zzz=
Customer (subscriber) number.
Event qualifier, where: E=new event(1) and R= restore (3)
Event code (3 hexadecimal digits), defined in the table on the next
page.
Always 00.
Zone/contact ID number reDortinathe alarm (001-099). or user number
(001-070) for open/close’repo~s. System ~atus messages (AC Loss,
Walk Test, etc.) contain zeroes in the ZZZ location.
TABLE OF CONTACT ID EVENT CODES
Code
Definition Definition
110 FireAlarm
333
RF ReceiverFailure-Trouble
121 Duress
373
Fire Loop Trouble
122
Silent Panic
380
Trouble (global)
123 Audible Panic
381
Loss of Supervision -RF
131 Perimeter Burgla~
382* Loaa of RPM Supervision
132 Interior Burglary
383* RPM Sensor Tamper
133 24 Hour Burgla~
384 RF Transmitter Low Battery
134 Entry/Exit Burglary
401
O/C By User
135 Day/Night Burgla~
403 Power-Up Armed
142* Polling Loop Short Alarm
406
Cancel by User
143 RF Receiver Failure-Alarm
407 Remote ArrnlDisarm (Download)
150 24 Hour Auxiliary
408
Quick Arm
301 AC
Loss
409 Keyswitch O/C
302 Low System Battery
411
Call back Requested
305 System Reset
570 Bypass
308 Program Tamper
602 Periodic Test
309 Battery Test Fail
607
Walk Test Mode
332* Poll Loop Shott-Trouble
*
● Notapplicableto4120XMsystem.
ADVISORY:
Ademco’s new Contact ID reporting is capable of uniquely reporting all 64 zones of information,
as well as openings and closings for all 70 users,
to central stations equipped with the Ademco
685 receiver using software level 4.4 or higher. 685 software levels below 4.4 cannot support
Contact ID reporting.
For information regarding updating the 685 receiver, or for a detailed listing of all possible Contact
ID reports for this panel, contact Ademco’s Technical Support group at 1-800-645-7492 (NY) or
1-800-458-9469 (CA).
-37-
Comentarios a estos manuales