ADEMCO 4120XM Guía de usuario descargar pdf (Pagina 34)

Other Trouble

A display of “COMM. FAILURE” (Alpha consoles) or “FCM(Fixed-word consoles)

Conditions

at the Console indicates that a failure occurred in the telephone communication

pottion of the system.

A display of “LO BAT” (Alpha consoles) with a zone number and descriptor, or

“BAT (Fixed-word consoles) with a zone number, and accompanied by a once-

per-minute beep at the Console, indicates that a low battery condition exists in

the wireless transmitter displayed.

The audible warning sound may be silenced by pressing any key.

A display of “SYSTEM LO BAT” (Alpha consoles) or “BAT” with no zone ID

(Fixed-word consoles) indicates that a low battery condition exists with the

system’s backup battery.

A display of “4281

SET UP ERROR” (Alpha consoles) or “E8” (Fixed-word

consoles) at the console indicates that a 4281 receiver is being used in a system

with more than 8 RF zones programmed.

If this is not corrected, none of the

zones in the system will be protected.

A display of “MODEM COM” (Alpha consoles) or “CC” (Fixed-word consoles)

indicates that the control is on-line with the remote computer and the control is

not operating.

A display of two numbers and “NO AC” (Fixed-word consoles) indicates the

control is in the programming mode and is not operating.

Power Failure

If the message “AC LOSS (Alpha consoles) or “NO AC” (Fixed-word consoles)

is displayed, the Console is operating on battery power only.

Check to see that the system’s plug-in transformer has not been accidentally

pulled out. Instruct the user to call a service representative immediately if AC

power cannot be restored.

-34-

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 79 80

Sin comentarios

ADEMCO 4120XM Guía de usuario Pagina 34