ADEMCO 4120XM Guía de usuario descargar pdf (Pagina 23)

6139 Deluxe

Addressable

Alpha Console

Mounting The

Consoles

Wiring Consoles

Powering Additional

Consoles

The 6139 Remote Console is keypad addressable (no DIP switches) console,

and features a red “ARMED” LED which lights when the system is armed, and a

green “READY” LED which lights when the system is ready to be armed (no zone

faults present). This console also features display backlighting. The keypad,

which is continuously backlit for ease in use, is located behind a flip-down

decorative door. The keypad also features dedicated panic keys, labeled A, B, &

C (the D key is not used).

Must be set to the non-addressable mode in this

system (Address 31).

The console can be surface mounted directly to a drywall, or to a single or double

gang electrical box. For flush mounting to drywall, use the optional 6139TRK

flush mount kit.

Note that field wiring to the consoles must be completed before the consoles can

be mounted.

The consoles can be either surface mounted or flush mounted (using an

appropriate Trim Ring Kit: 5137TRK or 6139TRK). Refer to the mounting

instructions and template included with the console and/or trim ring kit for specific

information.

Be sure to take the height of the users into account when mounting consoles.

If convenient, consoles should be wired on individual wire runs to the control. For

maximum wire lengths when using individual wire runs or multiple units wired on

a single run to the control, refer to Table 2 in the section on page 28 entitled

WIRING INFORMATION FOR CONSOLES, RF RECEIVERS, AND OTHER

DEVICES .

As indicated previously, all consoles can be powered from the auxiliary power

output provided that the 700mA rating is not exceeded for all devices drawing

power from the auxiliary output. The backup battery will supply power to these

consoles in the event that AC power is lost.

If necessary, additional consoles can be connected to the system by using a

regulated,

12VDC power supply (e.g., 487-12 supplies 12V, 250mA; 488-12

supplies 12V,

500mA). Use a UL Listed, battery-backed supply for UL

installations.

Connect the additional consoles as shown at left, using the console wire colors

shown. Be sure to observe the current ratings for the power supply used.

IMPORTANT: Make connections directly to the screw terminals as shown. Make

no connection to the console blue wire.

The 487-12/488-12 power supplies have a backup battery which can power these

consoles in the event of AC power loss. Note that consoles powered from

supplies which do not have a backup battery

will not function when AC power is

lost. In this case, be sure to power at least one console from the Control’s

auxiliary power output. “

tiumttl

POWER

I I~1 /l

-23-

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 79 80

Comentarios a estos manuales

Sin comentarios

ADEMCO 4120XM Guía de usuario Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4120XM