ADEMCO 4120XM Guía de usuario Pagina 26
- Pagina / 80
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Mounting the
Control Cabinet
Mounting The PC
Board
Advisory
Mounting The
Cabinet Lock
The 4120XM is supplied with a 12.5”W x 14.5”H x 3“D cabinet suitable for use in
residential and non-certified commercial burglary installations.
Mount the Control cabinet to a sturdy wall using fasteners or anchors (not
supplied). Install in a clean, dry area
which is not readily accessible to the general
public. The back of the Control cabinet has 4 holes for this purpose.
/nstall the PC board and cabinet lock only after the cabinet is mounted.
Before mounting the PC board, be certain that the appropriate metal knockouts
have been removed. DO NOT ATTEMPT TO REMOVE THE KNOCKOUTS
AFTER THE PC BOARD HAS BEEN INSTALLED.
1. Hang the three mounting clips on the raised cabinet tabs. Observe proper clip
orientation to avoid damage to the clip when mounting screws are tightened,
and to avoid problems with insertion and removal of the PC board.
2. Insert the top of the PC board into the slots at the top of the cabinet. Make
certain that the board rests in the slots as illustrated in step 2 detail (Fig. 6).
3. Swing the base of the board into the mounting clips and secure the board to
the cabinet with the accompanying screws, as illustrated in step 3 detail.
Make certain that the mounting screws are reasonably tight to ensure a good
ground connection between the PC board and the cabinet. Also, dress field wiring
away from the microprocessor (center) section of the PC board. The cabinet
provides 2 loops on its left and right sidewalls for anchoring field wiring using tie
wraps. These steps are important to minimizing the risk of panel RF interference
with television reception.
BTU2
STEP 1
MAIL SIOE VISW
OFSOAROlNSERTEO
INTO SLOTS
DETAIL SIDE VIEW 0+
REOUIRED
CLIP tNSTALbiTlON
A.CABINET TAB
WITHOUT CLIP
B-CABINET TAB
WITH HANGING CLIP
Figure 6.
MOUNTING
THE PC BOARD
1.
2.
Remove
the
lock
knockout on the control
cabinet cover. Insert the
key into the lock. Position
the lock in the hole
making certain that the
latch will make contact
with the latch bracket
when
the door is closed.
While holding the lock
steady, insert the retainer
clip into the retainer slots.
)
041TAIL SIOEVIEW
DFC2fCyD SOARD
I
I
I
u
—cmoa -
\
Figure 7. MOUNTING THE CABINET LOCK
-26-
- INSTALLATION 1
- INSTRUCTIONS 1
- I%U)EMCOI 1
- CONGRATUMTIONS! 3
- LIST OF ILLUSTRATIONS 6
- SUMMARY OF SYSTEM FEATURES 7
- BASIC 8 HARD-WIRED ZONES 10
- Zones 2-8 11
- TS2 HEAOER 12
- 4219 Zone Expander ● 13
- GeneraI Information 14
- /w%k%’wrO 15
- Wireless Zone Types 17
- Receiver Fault 18
- Annunciation 18
- 00000000 20
- ----- 21
- REMOTE CONSOLES 22
- I I~1 /l 23
- EXTERNAL SOUNDERS 24
- PHONE CONNECTIONS 24
- Ground Start Module 25
- OFSOAROlNSERTEO 26
- SIOEVIEW 26
- POWERING THE SYSTEM 27
- ❑ & ❑ (12V + and -) 28
- ❑ , 12V+ & Ground Return) 28
- SECURITY ACCESS CODES 29
- Assigning or 30
- Deleting Temporary 30
- Codes By User 2 30
- (Master User) 30
- CONSOLE KEYPAD FUNCTIONS 31
- [*I+ [W I B 32
- TROUBLE CONDITIONS 33
- Other Trouble 34
- Conditions 34
- Power Failure 34
- Split/Duai Reporting 35
- Ademco Low Speed 35
- Sescoa/Radionics 35
- 4+2 Reporting 35
- 4+2 Express 36
- Ademco High Speed 36
- Reporting 36
- No effect 38
- Programming Procedures 39
- Programming Steps 40
- Easy-To-Program 41
- Communication 41
- 010 BYPSSRst 43
- EIIEHIIE mHIIlsta*fd 44
- Klmmlmmtml 46
- (Q=no/l=yes) 48
- (Q/1 /2f3) 50
- (00;01-15) 53
- 1.34 communication 55
- Programming Zone 57
- Adding Custom 58
- Creating A Custom 58
- Message Display 58
- How Does 60
- Downloading Work? 60
- What Can Be Done 61
- Panel IS ● Bypass a Zone 61
- How Secure Is 61
- RED BLUE WHITE 62
- Using The Test 63
- Turning The System 64
- Over To The User 64
- Remote Consoles 65
- Hard-Wired Zones, 1-8 65
- Wireless 66
- Communications 67
- X 4.75”H X 1.25” D 69
- (DOC) STATEMENT 73
- ADEMCO LIMITED WARRANTY 75
- N6493V1 10/93 76
- 4120XM PROORAMM8NQ FORM 77
- ❑ clclclclclclcl 78
- ❑ 0000000 78
- ❑ lmnclclcl 78
- ❑ lnciclnclcn 79
- DISABLETROUSLESOUNDERFORRF 80
- DivisionOf PittWytirf.watia’t 80
Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4120XM
Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista-20HW Guía para resolver problemas
(100 paginas)
(100 paginas)
Los Sistemas De Control De Acceso De Seguridad ADEMCO Security System VISTA-10SE Manual de usuario
(24 paginas)
(24 paginas)
(56 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales