ADEMCO 4120XM Guía de usuario Pagina 32
- Pagina / 80
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Arming Functions
The following is a brief list of system commands. For detailed information
concerning system functions, refer to the User’s Manual.
Disarmed /Not Ready Before arming, the system must be in the READY
condition (all zones must be intact). If the “NOT READY”
message appears, press the READY [*] key to display
faulted zones.
Arming Away
Enter code + AWAY [2].
Arming Stay
Enter code + STAY [3].
Arming Instant
Enter code + INSTANT [7’1.
Arming Maximum
Enter code + MAXIMUM [4].
Disarming
Enter code + OFF [1].
Bypassing Zones
Enter code + BYPASS [6]+ zone number.
To automatically bypass all faulted zones, use the “Quick
Bypass” method: Enter code + BYPASS+ [#].
Chime
Mode
Enter code + CHIME [9]. To turn chime
mode off, enter
code + CHIME again.
SUMMARY OF ARMING MODES
Mode
Features For Each Arming Mode
Exit
Entry
Perimeter Interior
Delay
Delay Armed
Armed
AWAY Yes
Yes Yes
Yes
STAY
Yes Yes
Yes
No
INSTANT
Yes No
Yes
No
MAXIMUM Yes
No
Yes
Yes
Panic Keys
Some consoles make use of three key pairs for panic, while others are equipped
with three separate panic keys (see below). If programmed, they can be used to
manually initiate alarms and send a report to the central station. Each key pair (or
single key) can be individually programmed for 24-Hour Silent, Audible, Auxiliary
or Fire responses. The panic function is activated when the appropriate key (or
key
pair) is pressed. Key pairs must be pressed at the same time.
The panic functions are identified by the system as follows:
[*I+ [W I B
1991
For Alpha consoles, these panic keys can also be
descriptor.
Important: For the silent Panic functions to be of
must be connected to a central station.
programmed with an alpha
practical value, the system
Viewing Downloaded
Users may occasionally receive messages on the console display from their
Messages (Alpha
installation company. When this occurs, the console will display the following:
Consoles Only)
“Message. Press Ofor 5 sees.”
Instruct the user to press and hold the [0] key to display the central station’s
message. Note that the system must be in the READY state to view these
messages.
-32-
- INSTALLATION 1
- INSTRUCTIONS 1
- I%U)EMCOI 1
- CONGRATUMTIONS! 3
- LIST OF ILLUSTRATIONS 6
- SUMMARY OF SYSTEM FEATURES 7
- BASIC 8 HARD-WIRED ZONES 10
- Zones 2-8 11
- TS2 HEAOER 12
- 4219 Zone Expander ● 13
- GeneraI Information 14
- /w%k%’wrO 15
- Wireless Zone Types 17
- Receiver Fault 18
- Annunciation 18
- 00000000 20
- ----- 21
- REMOTE CONSOLES 22
- I I~1 /l 23
- EXTERNAL SOUNDERS 24
- PHONE CONNECTIONS 24
- Ground Start Module 25
- OFSOAROlNSERTEO 26
- SIOEVIEW 26
- POWERING THE SYSTEM 27
- ❑ & ❑ (12V + and -) 28
- ❑ , 12V+ & Ground Return) 28
- SECURITY ACCESS CODES 29
- Assigning or 30
- Deleting Temporary 30
- Codes By User 2 30
- (Master User) 30
- CONSOLE KEYPAD FUNCTIONS 31
- [*I+ [W I B 32
- TROUBLE CONDITIONS 33
- Other Trouble 34
- Conditions 34
- Power Failure 34
- Split/Duai Reporting 35
- Ademco Low Speed 35
- Sescoa/Radionics 35
- 4+2 Reporting 35
- 4+2 Express 36
- Ademco High Speed 36
- Reporting 36
- No effect 38
- Programming Procedures 39
- Programming Steps 40
- Easy-To-Program 41
- Communication 41
- 010 BYPSSRst 43
- EIIEHIIE mHIIlsta*fd 44
- Klmmlmmtml 46
- (Q=no/l=yes) 48
- (Q/1 /2f3) 50
- (00;01-15) 53
- 1.34 communication 55
- Programming Zone 57
- Adding Custom 58
- Creating A Custom 58
- Message Display 58
- How Does 60
- Downloading Work? 60
- What Can Be Done 61
- Panel IS ● Bypass a Zone 61
- How Secure Is 61
- RED BLUE WHITE 62
- Using The Test 63
- Turning The System 64
- Over To The User 64
- Remote Consoles 65
- Hard-Wired Zones, 1-8 65
- Wireless 66
- Communications 67
- X 4.75”H X 1.25” D 69
- (DOC) STATEMENT 73
- ADEMCO LIMITED WARRANTY 75
- N6493V1 10/93 76
- 4120XM PROORAMM8NQ FORM 77
- ❑ clclclclclclcl 78
- ❑ 0000000 78
- ❑ lmnclclcl 78
- ❑ lnciclnclcn 79
- DISABLETROUSLESOUNDERFORRF 80
- DivisionOf PittWytirf.watia’t 80
Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4120XM
Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista-20HW Guía para resolver problemas
(100 paginas)
(100 paginas)
Los Sistemas De Control De Acceso De Seguridad ADEMCO Security System VISTA-10SE Manual de usuario
(24 paginas)
(24 paginas)
(56 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.111 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales