ADEMCO 5130XM Manual de usuario descargar pdf (Pagina 12)

DISARMING THE SYSTEM

AND SILENCING ALARMS

(FOR AWAY, STAY, INSTANT, AND MAXIMUM ARMING)

PROCEDURE

1.

2.

Enter security code and press

OFF [1]. The Ready message will

be displayed and the console will

beep once to confirm that the

system is disarmed, unless an

alarm has occurred.

If an alarm has occurred, note the

zone descriptor displayed and

repeat step 1 to restore the Ready

RESULT

Any alarm sounders will be silenced”

ALARM and zone descriptor

Y

displayed) will clear only when th

open sensor is closed.

A fire alarm is indicated by a display of

both FIRE and the zone descriptor on

the Console. These will clear only

when the fire zone is again intact.

message display. If the message

See

“SUMMARY OF AUDIBLE

will not display, go to the displayed

NOTIFICATION”

section for

protection zone and remedy the

information which will enable you to

fault (close windows, etc.). If the

distinguish

between FIRE and

fault cannot be remedied, notify

BURGIARY alarm sounds.

the alarm agency.

11

DURESS CODE

(WHEN FORCED TO DISARM/ARM

Enter the first three (or 5) digits of the

security code. Increase the final digit

by one and then press OFF (or

AWAY, etc. if arming the system).

The system will disarm (or arm), but

can silently notify the central station

of your situation, if that service has

been provided.

For example, if the Normal security

code is”1 23 4“, the Duress security

code is”1 23 5“.

-12-

--0

1

UNDER THREAT)

IMPORTANT

● This code is useful only when

connected to a central station.

● Duress code capability is not

present for codes ending in 9.

● Users of temporary codes must be

instructed to enter their codes

carefully to avoid the possibility of

accidentally entering the Duress

code.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comentarios a estos manuales

Sin comentarios