
VISTA-10SE Installation and Setup Guide
1-2
Optional
VIP Module
•
Supports the ADEMCO 4285/4286 VIP Module.
•
Provides access to the system via on-premises or off-
premises phones for arming, disarming, etc., plus
control of relay outputs.
Optional Long-Range Radio
Allows all messages that have been programmed to go
to the primary telephone number to be reported
additionally to a 7720 PLUS, 7820 or 7835C radio.
Alarm Output
•
Provides a 12VDC, 2 AMP output that can drive the
compatible sounders listed in
SECTION 13:
Specifications and Accessories
(assumes a fully
charged battery is connected).
•
Steady output for burglary/panic, or temporal pulse
sounding output for fire notification, as required by
UL.
•
Uses current-limiting circuitry for protection.
Auxiliary Power Output
•
Provides 12VDC, 500mA maximum. Uses current
limiting circuitry for protection.
•
This output interrupts for smoke detector reset if 4-
wire smoke detectors are used.
Programming
•
Programmed options are stored in electrically
erasable, nonvolatile EEPROM memory
(information can be reprogrammed at any time and
will not be lost in the event of a power loss).
•
The system can be uploaded, downloaded, or
controlled via an IBM-compatible computer, using
ADEMCO's
Compass
Windows downloading
software, and a modem specified by ADEMCO.
Keypad programming consists of:
•
Data field programming.
•
Interactive (menu) mode programming.
For programming from a keypad, a 6139 2-line
alpha keypad must be connected (but need
not stay in the system).
Communication Formats Supported
•
ADEMCO Low Speed (Standard or Expanded)
•
Sescoa/Radionics (Standard or Expanded)
•
ADEMCO Express
•
ADEMCO Contact ID
®
Zone Descriptors
You can assign alpha descriptors to all zones (useful
only when using alpha keypads and/or the 4285/4286
VIP Module).
AC Power Supply
Uses No. 1321, 120VAC plug-in transformer with
16.5VAC 25VA output (1321CN in Canada).
Backup Battery
Rechargeable (Sealed Lead Acid) 12VDC, 4AH
minimum.
Comentarios a estos manuales