ADEMCO VISTA 10 Guia de preparacion descargar pdf (Pagina 10)

VISTA-10SE Installation and Setup Guide

2-2

Mounting Control with RF Receiver

To mount the control panel and RF receiver boards

together in the cabinet, do the following:

1. Hang two mounting clips (provided with receiver) on

the raised cabinet tabs, as indicated in the upper left

diagram in Figure 2-3.

2. Insert the top of the receiver board (removed from

its own case as described in

its

instructions) between

the rows of slots at the top of the cabinet, as shown

in Detail A.

3. Position the base of the receiver board onto the

mounting clips and secure both to the cabinet with

the supplied screws.

4. Hang two

mounting clips (supplied with the control

board), on the raised cabinet tabs as shown in

Figure 2-3.

5. Insert the top of the control board into the slots of

the mounting clips secured in step 3 above.

6. Position the lower end of the control board into place

on the mounting clips and secure both to the cabinet

with the two supplied screws.

7. Insert both grounding lugs (supplied with the

receiver) through the top of the cabinet into the

left-

hand

terminals of the antenna blocks (located at the

upper edge of the receiver board), and secure them

to the cabinet with the screws provided, as shown in

Detail B.

8. Insert the receiver's antennas through the top of the

cabinet, into the blocks'

right-hand

terminals, and

tighten the screws.

Refer to setup and wiring instructions for the receiver

in the

Installing the 5881/5882 Receiver

paragraph

later in this section.

NOTES

•

Do not mount the cabinet on or near metal objects.

This will decrease RF range and/or block RF

transmissions from wireless transmitters.

•

Do not locate the cabinet in an area of high RF

interference (revealed by frequent or prolonged

lighting of the LED in the receiver after it is

operational (random flicker is OK)

ANTENNA

MOUNT

(2 PLACES)

ANTENNA

(2)

SCREW

(2)

BLACK

MOUNTING

CLIP

RED

MOUNTING

CLIP

WHITE

MOUNTING

CLIP

GROUNDING

LUG

(2)

NOTE

A COMBINATION OF THESE MOUNTING CLIPS HAS BEEN

INCLUDED IN YOUR INSTALLATION KIT.

USE THE APPROPRIATE CLIPS FOR MOUNTING.

IF NO RF RECEIVER IS USED, MOUNT THE PC BOARD USING

EITHER THE WHITE OR BLACK CLIPS, WHICHEVER ARE

INCLUDED IN THE CONTROL PANEL'S HARDWARE KIT.

DETAIL A

SIDE VIEW

OF BOARD -

SUPPORTING SLOTS

CIRCUIT

BOARD

CABINET

MOUNTING

CLIP

CABINET

MOUNTING

CLIP

CONTROL

CIRCUIT

BOARD

SUPPORTING

SLOTS

RECEIVER CIRCUIT BOARD

pc_mount-001-V1

DETAIL B

ANTENNA AND GROUNDING

LUG INSTALLATION

INSTALLATION WITH RECEIVER CIRCUIT BOARD

Figure 2-3. Mounting the PC Board and RF Receiver

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 79 80

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA 10 Guia de preparacion Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA 10